Such a signal is optimal for use with electrical Transformers and household appliances. When you simply chop up DC current and send it through a transformer, that is a square wave, and square waves don't help the life of the transformer. Depending on the length of the cycle and the load, that could cause the transformer to get hot.
The feed back factor in the oscillator refers to the output which is usually sinusoidal.
When a low pass filter is used with a sine wave input, the output is also a sine wave. The output will be reduced in amplitude and phase shifted when the frequency is high, but it is still a sine wave. This is not the case for square or triangular wave inputs. For non-sinusoidal inputs the circuit is called an integrator.
Audio output frequency is that range of frequencies that can be heard. For humans, that is generally considered to be the range of 20Hz to 20kHz.
3MHz
The frequency would decrease the gain and increase the output voltage
A linear circuit is an electric circuit in which, for a sinusoidal input voltage of frequency f, any output of the circuit (current through any component, voltage across any component, etc.) is also sinusoidal with frequency f. Note that the output need not be in phase with the input.
AC generators have a varying waveform which is sinusoidal in nature, whereas a DC output is linear.
if a sinusoidal voltage is applied to linear circuit the output voltage is also sinusoidal in nature as far as the waveform is concerned the amplitude of input signal may change and there may be phase displacement between input voltages and output voltages
The feed back factor in the oscillator refers to the output which is usually sinusoidal.
AC generators have a varying waveform which is sinusoidal in nature, whereas a DC output is linear.
When a low pass filter is used with a sine wave input, the output is also a sine wave. The output will be reduced in amplitude and phase shifted when the frequency is high, but it is still a sine wave. This is not the case for square or triangular wave inputs. For non-sinusoidal inputs the circuit is called an integrator.
twice the input frequency
Audio output frequency is that range of frequencies that can be heard. For humans, that is generally considered to be the range of 20Hz to 20kHz.
In natural frequencies the output of the system will be less than the maximum level. In the resonance frequency the output of the system will be the maximum level.
answer for me please
There are several methods for generating FM signals but they all basically involve an oscillator with an electrically adjustable frequency. This type of oscillator uses an input voltage to affect the frequency of its output. For example, when the applied voltage increases, the oscillator output frequency increases and when the applied voltage decreases, the oscillator output frequency decreases as well. If no voltage is applied to the oscillator its output will be a signal at its centre frequency. The amount of frequency variations is deviated around the oscillators' centre frequency.
3MHz