answersLogoWhite
Oil and Oil Filters
Check Engine Light
Ford Expedition XLT

Why is the engine oil light still on after an oil change was done on the E320?

123

Top Answer
User Avatar
Wiki User
Answered 2011-08-26 02:39:55

The oil change garage or Mercedes dealer has to reset the oil change light.

The oil change light goes by the mileage on the car, tripping the light on at the factory recommended oil change intervals.

The computer doesn't know you changed the oil in the car unless you tell it.

Read your car owners manual.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


Have vehicle scanned to determine the problem and reset codes


I want to change my low beam left side light on my Mercedes E320 can i change this myself or do i need to go to a dealer i already bought the replacement bulb myself


Is this possible, After looking for the worst like having to change the (ECU) I found the right side marker light out .. and after changing it the Ck engine electronics light went out and the car seems to be ok. I still have a problem..the not blowing cold ac is charge the compressor comes on, but no cold air… any ideas


how to reset time on mersedes E320 2003


No, not normally. Timing chains are designed to last a life of the engine and are normally replaced during a complete engine overhaul.


7.5 liters OR 8.0 quarts for W211 E320


How to change cabin air filter Mercedes E320



how to replace the headlight light assemble on a 2001 e320


Nothing as long as it doesn't ping or set the check engine light.


If the turn signal light keeps burning out on an E320, it is likely moisture related. It is likely that a seal is leaking.


The Car Specifications of the Mercedes E320 are that the Model Number represents the engine size, an E320 has a 3.2 liter engine. The E320 was available in a 4 door Sedan or a 5 door Station Wagon. The engine was in front. It had a 5 speed or 7 speed automatic transmission and had a standard drive option of a front wheel drive with a 4 wheel drive option.The E320 was manufactured between 1993 and 2009.


It depends what is wrong with the engine.


Take it to Autozone since it is OBD2 they will be able to get some generic codes from their scantool and can help you further.



The 2002 Mercedes-Benz E320 fuse box is located in the engine compartment. The fuse box will be on the drivers side of the engine compartment.


What kind of engine oil is recommended for a 1997 Mercedes E320?Read more: What_kind_of_engine_oil_is_recommended_for_a_1997_Mercedes_E320


It is under the hood between the engine and the bottom of the windscreen


1 http://wiki.answers.com/Q/Were_is_the_data_link_conector_for_a_2000_mbz_e320_located is the data link conector located fir a 2000 mbz e320 2 how do i change the cabin filters - 2000 mbz e320 3 how do i change the blower regulator - 2000 mbz e320


Open the hood, get to the back of the light, remove the rubber cover and the light is visible. Turn the light bulb housing and pull the bulb out. Installing is the reverse.



Apparently the engine was exchanged in1998 by a 3.2L SOHC V6. If engine number E320 1996 should be located, chances it would be found via salvage provisions or manufacture direct.


Begin by removing the wiring harness from your third brake light. Remove the third brake light retaining screws. Reverse the process to install your new third brake light.


See the related link below for step by step instructions with pictures on how to change the transmission fluid in your 1999 MB E320.


You should take it to a MB daler and tell them to reset the computer, it shouldn't cost you anyhing. If the light does not go away, there may be a problem with the sensor.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.