Want this question answered?
A garlic press is a class 2 lever
A garlic press uses a lever and has its fulcrum at one end of the lever arm. The load (garlic) is between the fulcrum and the effort. When using a simple machine like the garlic press we gain a mechanical advantage by increasing the amount of force we wish to use.
third class of liver
A garlic press is a kitchen tool, consisting basically of two levers connected by a hinge. There are small cups on the end of the levers opposite the hinge that nest inside each other. To use, separate the levers, place a clove of garlic in the cup, and then close the other lever on top of the garlic. Press the levers together and the garlic will fall through very small holes in the bottom of the cup. The garlic press is ideal to use when recipes call for "very finely minced garlic."
They use a garlic press to pulp the garlic to get more flavour
You could use a garlic press, or use the flat of a broad kitchen knife to press down on the clove of garlic.
A class three lever is where the load is one side of the force and the fulcrum is on the other side of the force. An example is a pair of tweezers. Another example is the secondary lever in a pair of fingernail clips, i.e. the part that closes on the fingernail. (The first lever in a pair of fingernail clips, i.e. the part that you press on, is an example of a second class lever.)
The answer is: a lever.A lever is a simple machine that has a stick that pivots at a point called a Fulcrum.There are 3 types of Lever:First class lever: A first class lever is when a fulcrum is in the middle of the input force and the load. An example is a seesaw in the playground. When you press down the side of seesaw,(input force) the other side goes up. (load, output force) In the middle, there is a fixed point.Second class lever: A second class lever is where you have the load in the middle of the Fulcrum and the input force. An example would be a wheelbarrow. The basket in the middle is the load( also called the output force) the wheel at the end is the Fulcrum, and the handle that you press up and down is the input force.Third class lever: A third class lever is a lever that has a input force in between the Fulcrum and the Load. An example is a Hammer. The sharp part is the load(output force) the part you grab and swing is the input force, and the other end of the hammer is the Fulcrum.
At Target
In this case the clove of garlic should be chopped into small pieces, instead of crushing with a garlic press in the normal manner.
A garlic press is a kitchen utensil to crush garlic cloves efficiently by forcing them through a grid of small holes, usually with some type of piston. Many garlic presses also have a device with a matching grid of blunt pins to clean out the holes.
kasura nmn to!