Depending on the year of the vehicle, Chrysler had some issues with their ignitions from the 1998 - 2004 range. The ignition switches wear badly and rather than getting it repaired, alot of times it is more cost effective to just have the ignition cylinder replaced. To tell the truth, you could get the original repaired and then end up a week later with the same issues.
Lack of lubrication. Spray the tumbler with an electronic cleaner. Then spray the tumbler with powdered graphite you can buy at any hobby store or Walmart. Do not use WD40 or any other spray lubricant.
The easiest way to test ignition coils on a 1992 Mustang 2.3 is to use an ohmmeter on the leads going into the coils.
No electrial spark or fire at the plugs.
If the old plugs and wires were bad I would expect the engine to start and run better.
It really needs to be diagnoised since it can be a wire or the ignition switch itself.
GO BUY A NEW IGNITION SWITCH AND KEY SET TO INSTALL IN THE COLUMN. It's not that simple smart#@$! If anyone can answer the question intelligently I would appreciate it.
A computer from a 1992 Wrangler with the same engine is what is compatible.
They didn't make a 1996 Wrangler...
no
No.
it will fit no problem
yes
The correct factory tire size for a 1992 Jeep Wrangler is 215/75R15.
Yes
Six quarts of oil are needed to change the oil on a 1992 Jeep Wrangler.
A 1992 Jeep Wrangler with the 4-cylinder takes 4 quarts, and the 6-cylinder takes 6 quarts.
No. Don't waste you time.
Where is the fuel pump RELAY on a 1992 Jeep Wrangler