Want this question answered?
Yes there is, if you look behind the controller, right above the sticker is a hole with a screw in it, now if you look a little to the right if the hole, you will see a small hole, the reset button is located in there.
Any cam will fit in the hole, but that's not to say that it will produce the right amount of lift and duration to suit the motor. It's also possible to put in a cam with so much lift it will cause the valves to hit the pistons.
Bearing in motor seizing Try removing motor and drilling small hole in end to lubricate--sometimes this works
Rabbit Hole - 2009 was released on: USA: December 2009
Try drilling a very small hole at the rear of the motor to lubricate the bearing
The small hole is for headphones.
what does a microscope have a small hole in it
In my 1989 century, its in the glovecompartment behind a small door with a hole in it. No 3 from top to the right. Problem with the antenna motor running after ignition cut? Hope you excuse my imperfect english. Ray Norway, Eu
Usually it is a sealed unit - but if you remove blower motor and drill a small hole in the rear and spray a lubricant into it ,it may help Usually it is a sealed unit - but if you remove blower motor and drill a small hole in the rear and spray a lubricant into it ,it may help
yes if there is hole in the diesel tank in motor
check your water pump it has a weep hole in the bottom and will usually run down the front right side of motor
Because you presumably want your hole to be the right size, not too small or too big.