answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Why is your 1989 Nissan Pulsar idling too high at start up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where can you find a wiring diagram for a 1989 Nissan Pulsar?

http://www.commandocaralarms.com/wiring/1989/Nissan/Pulsar


What is the fluid capacity for 1989 Nissan Pulsar automatic transmission?

40 litres


Does the 1989 Nissan Pulsar have a timing chain or a timing belt?

In a 1989 Nissan Pulsar NX : The 1.6 litre four cylinder engine has a timing CHAIN The 1.8 litre four cylinder engine has a timing BELT


What is the engine timing for a 1989 Nissan Pulsar?

On a 1.6 litre, it's 7 degrees btdc.


What fuses go where on a 1989 Nissan Pulsar fuse cover is gone?

To ensure your safety, please call or visit your local Nissan Dealership. Thank You. -Nissan of America. :) :) :)


Where is the fuel pump relay located on a 1989 Nissan Pulsar?

It's a green relay located under the left (driver's) side of the dash


Can you use unleaded 10 percent ethanol on your Nissan Pulsar 1989?

Possibly not. For on some cars, the ethanol component can damage seals. But you should check with the car manufacturer, in writing!


1989 Nissan Maxima?

i was wondering if my Nissan maxima has a filter i can change myself 1989 model


Toyota Corolla 1600GL 1989 16 valves. does not hold the idling?

My Toyota corola 1.6gl 1989mod 16valve, lost the idling. wat can i do to fix it?


How do you time 1989 Nissan 1600cc engine?

How to Set timing on nissan sentra 1600cc 1989 model


Does 1989 Nissan 4x4 v6 truck have same transmission as 1989 Nissan 4x4 4cylinder truck?

no


How do you replace the starter on a 1989 16 pulsar?

I was able to change the starter on my 1989 Nissan pulsar, by first lifting the front of the car. Then I placed a jack under the passenger side of the engine. Then remove the bolt from the passenger side of the motor. Then jack the side of the engine till you can access the bolts on the starter. The bolts also serve as a mount for the transmission. There is one wire hookup. The stud on the starter is a light guage metal, and can be striped very easy. So be careful.