because they had to much to do. everyone wnat a slave.
hard
they were looking for strength and physical looks. They also were looking for how hard a slave worked.
suck it hard bithchezz
slave
To remove a partition on a slave hard drive you can go into the BIOS. You should look up a guide if you plan to do this.
Hard drive as master and DVD writer as slave.
In computing, you can have two disks, the main and the slave - these are set by jumpers on the hard drive. In classical hardware, the main would have priority over the slave. However, with better electronics's, most computers don't differentiate between slave and main anymore.
Hard
Configure the hard drive as the master and the CD-ROM as the slave.
There are jumpers on the drive itself that can be configured to set it up as a master or a slave. Refer to your hard drive's documentation for the pins to use for these configurations.
By default the computer boots the XP installation on the Master hard disk. If you need to access the slave system change slave to master.
Hard Drive configuration is used to define the Slave and master Hard Drive. When we are attaching more than one hard drive the configuration is used. Configuration is done by jumper setting which is available in back side of hard drive...1st two pins for master hard drive and last pins are slave..