computer keyboards are made from ABS (Acrylo-nitrile-butadiene-styrene) plastic
The "main relay" is inside the abs computer. If you have the Main Relay code, the abs computer has failed.
The 4 main things that need to be checked and or replaced before replacing the computer with an ABS system are the pads, the rotors, the calipers, and the shocks. Also make sure to look over the brakes as well before putting in the ABS system.
You have to repair the malfunction that caused the code stored in the abs computer.You have to repair the malfunction that caused the code stored in the abs computer.
Need an ABS scanner <> Yes ABS required, but most professional scanners have that included. First, verrify that you are connecting to the correct test port. Check the fuse to the ABS CM. (computer) If it is good, verrify that the power is actually getting to the computer, do this with A test light. Make sure it is grounded as well. If all is good, It is likely that the computer is bad and that is the reason you are wanting to test it in the first place. Good luck,.
Because the abs computer has detected a malfunction and set a code. Have the abs checked for codes and you will know what to diagnose.
The computer has detected a problem with the ABS ( Anti-lock Brake System ).
The abs computer has detected a malfunction and set a code.
It means that the ABS computer has detected a fault with the ABS circuit, meaning that there is a problem with a wheel speed sensor, the ABS computer or the actuator. You'll need to have the ABS diagnostic codes read to find out what the computer thinks is wrong.
It is on because the abs computer has detected a malfunction and set a code.
The ABS computer has detected a malfuction and set a code.
engine computer is located under the dashbord, to the left of the steering column. The ECU and the ABS computer are mounted in the same carrier, the ABS computer is outbord of the engine computer. the engine computer is the one closest to the kickpannel.