It may be because there is a fuse blown that is used for that circuit. Your owner's manual would come in handy for this, as it would show you where the fuse is located.
a button on your emerson remote control
IF the Remote Control is also a part of an Alarm System, you will find a small BUTTON somewhere under the Dashboard. Mine is located just to the left of the steering column UNDER the dash. With the door open you can spot the button while the light under there is lit. Put your key in the starter - DO NOT turn on - and press the button for just a couple of seconds ( 2 or 3 ) then remove the key. Press the Remote Starter. Good Luck.
The button just above green square on the bottom of remote.
A remote is a button pressed device that you change the channel with or a remote to control something.
To use PIP on a Charter remote control a person will need to press the PIP button on the remote. Then enter the channel number of the station they wish view in the PIP window and press the select button.
To program a GPT universal remote control, hold down the power button at the same time with the button for the device that is going to be programmed. When the other buttons on the remote blink, let up and press on the power button again. The device should turn on. If not, repeat the process.
Use the AUDIO button on your remote control
The +Control Pad above the A button on the Wii Remote.
There is no Select button on an XBOX 360 controller. There is a "Start" button, a middle home button (The large "X") and a "Back button".
Once the DISH remote is programmed to your DVD player, it can be operated in AUX mode. To get to that mode, press the AUX button on the upper right corner of the remote control.
Simply press the alarm button on the dashboard while swithcing the key on and of for 5 times
I do not have the code for my samsung dvd/vcr combo model vr370 to enter into my tevion big button universal remote control