answersLogoWhite

0

Why motor need pole?

User Avatar

Anonymous

15y ago
Updated: 8/17/2019

electric and magnetic go hand in hand. One needed to produce other. Motor no magnetic pole, motor no work.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Is the tekin SC4X motor a 4 pole motor?

it is a 20 pole motor


How can you wire a 3-pole isolator to disconnect a 6-wire star delta motor away from the mcc and near the motor?

You can't. You need a 6 pole isolator


What are the benefits of a three-pole motor over a two-pole motor?

A 3-pole motor has a smother torque curve.


What is differene between 2 pole 4 pole electric motor?

A 2-Pole motor runs twice as fast as a 4-pole motor. The 2-pole motor has 2 windings at 180 degrees apart and the four pole motor has four windings at 90 degrees apart. The rotor tries to move from pole to pole with each half cycle of the AC current so the motor no-load speed for 60 cycle current is 2x3600/#poles. This is 1800 rpm for a 4-cycle motor and 3600 rpm for a 2-pole motor.


2 pole motor vs 4 pole motor?

A 2-pole motor has about 1.5 ft-lbs of torque per horsepower where a 4-pole motor has 3 ft-lbs of torque. also the speed of a 2-pole motor is twice that of a 4-pole motor. The speed of a motor is determined by: speed=(120 x freq)/no. of poles At 60 Hz, a 4-pole motor is about 1800 rpm where a 2-pole motor is 3600


Which motor used in refrigerator?

shadded pole motor


Why pole changing method of speed control of three phase induction motor can not be used?

because its possible only where pole changing arrangements are given and pole changed motor draws more current then its actual pole which damages its windings.


How can you wire a 6-pole isolator to disconnect a 6-wire star delta motor away from the mcc and near to the motor?

There is no need to place a 6 pole disconnect to isolate the motor in the field. The motor's leads at the motor's terminal box have to be wired for a delta connection. The star delta contactor in the MCC only has three wires on its output. Six wires do not have to be taken directly to the motor. The voltage is reduced at the start of the circuit when the starter in in the star configuration. From the star configuration it changes to the delta configuration. So as you can see only a three pole isolation switch is needed in the field to isolate the motor from its supply.


What kind of motor uses a differential reluctance pole to produce starting torque?

shaded pole


What is the relationship between motor POLE and RPM?

Relationship between motor rpm and no of poles


What are the types of motor using in table fan?

The motor used in a table fan is usually a shaded pole motor.


What is the advantage by using 8 pole motor instead of 6 pole motor?

The number of poles in a motor will determine the speed of that motor. n=speed, f=frequency, p=# of poles. n=(120f)/p So a 6 pole motor is rated to operate at n=(120*60)/6=1200 rpm. assuming 60Hz frequency Or a 8 pole motor is rated to operate at 900 rpm. Of course due to slip the rotor will always spin slightly slower.