Unlock the chain brake
sprocket worn out, chain brake on....does chain turn free by hand?
If the drive sprocket is worn out on your chainsaw, the chain will not turn. This is the biggest indicator that it needs repair.
Some Stihl chain saws have an adjuster underneeth the saw to turn up the oiler .
It has a timing chain. A MAIN timing chain runs around the twin over head cams and crankshaft and a SECONDARY chain (balance shaft chain) runs off the crankshaft to turn the water pump. Both have timing marks and the balance shaft chain runs behind the timing chain.
Lossen the two bolts on the side of the chain bar, then use a straight screwdriver and straight under the chain turn the screw clockwise, don't tighten it to much, make sure it still turns, then tighten the bar bolts
The 2.0L engine found in Chevrolet Trackers utilizes an upper timing chain that runs the intake and exhaust camshafts, while the lower runs a center gear which in turn, runs the upper chain. The lower chain on mine broke due to a worn timing chain guide.
Chainsaw?
the aux shaft your refering to is the shaft which runs of the the timing chain which in turn drives the distributor.
no, ive seen chainsaw wounds, a number of them, imagine what it would look like if a lion mauled a human, multiply that by 10 and you have a chainsaw wound, they don't cut flesh, they shred it
a magnetic chain reaction is a dik that when turn around by its magnet and then others turn as well.
If you have installed a timing chain and the engine will only turn a half a turn, you are out of time and may have bent valves.If you have installed a timing chain and the engine will only turn a half a turn, you are out of time and may have bent valves.
need to adjust high speed jet in carberator, turn in all the way then back out about 1 turn out and go from there.