The reason for no ignition light could be a low battery. The wiring system may be another reason for this. Check the white wires in the ignition switch and the multi-plug connector to ensure they are connected.
Ignition must be ON.
Yes, when you turn on the ignition the Check Engine light will come on for a few seconds to show you the light is working. It will go out if no problem is detected.
bulb no good.
the light in the dash has been removed or blown out.
no. you have to take the whole light out
ensure there is diesel in the car. Turn on ignition but don't start the engine yet. Watch dashboard and look for a small light (not ignition light) look for a heater plug light. When this goes off then turn ignition full turn and engine should start.
you have an engine/ignition problem. HAve a garage read the codes and diagnose the problem soon.
You have a flat battery.
Set it to trip A and hold reset turn ignition off then turn ignition on and maintenance light will flash and your done.
ignition on for 15 mins remove key reinsert ignition on light should go out hope this helps
ignition off press and hold the button next to the seatbelt light switch on ignition keep the button down untill display is at 0 and spanner is off turn ignition off All O:K:
Yes, the ignition switch must be in the ignition position -not- the accessory position.