the potential at which neon bub just start glow is called flashing potential.and quenching potential is a potential at which neon bulb stop to conduct..
A small amount of vapours of a substance having low ionization potential, called as quenching gas, eg alcohol vapours, is added to gm tube, which discharges at cathode before the principle gas +ve ions which discharges at cathode in about 10^-4 seconds. So the quenching gas neutralizes itself and also the tube....
because of charging and discharging
It is due to the charging and discharging of capacitor in the circuit....
The essential difference between soft iron and hard iron is in the crystalline structure of the metals. This is sometimes due to the presence of impurities, but the over-riding effect is that of heat treatment. The basic techniques (for iron) are to get it white-hot, then cool it slowly; this produces soft iron. Alternatively, get it dull red, or bright red, or yellow, or white, then plunge it into cold liquid. This process, called quenching, hardens the iron. Picking the correct colour before quenching gives just the hardness needed.
quenching means (the act of extinguishing; causing to stop burning) "the extinction of the lights"
That is the correct spelling of "quenching" (eliminating, extinguishing).
Color quenching is the attenuation of photons produced by a scintilator due to absorption and scattering. This effect, combined with the chemical quenching (attenuation of the transfer of energy from the solvent to the scintillator gives the total quenching effect of the scintillator/solvent mix.
The fluid for quenching is specific for each type of steel; choosing an inappropriate fluid lead to bad results.
Quenching is done when you need to obtain the hardest, toughest form of the metal / polymer. For instance, when a steel is quenched in water it gets much harder and mechanical resistant but also more brittle than if it was allowed to cool down in a oven or at air.
Quenching your thirst ;)
stopping the ionization cascade modern geiger-muller tubes use a halogen gas for quenching
to avoid the high internal stresses caused by quenching and to get tempered Martensite that is less brittle
quenching quiet
quenching
the potential at which neon bub just start glow is called flashing potential.and quenching potential is a potential at which neon bulb stop to conduct..
In the normalising metal treatment process, the metal is cooled slowly and gradually while in quenching metal treatment process the metal is called very fast and abruptly.