Wet mounts are not attached to the slide, it is "floating". If you use an oil immersion lens, you have to put a drop of oil on the slide cover so the light can correctly focus. The oil will cause the slide cover to stick to the end of your Oil immersion lens. When you focus the field of focus will stay the same since the slip cover is stuck to the lens. When you go to change objectives, the cover will travel with your oil immersion lense.
oil immersion
False
The objective lens that focuses closest to the slide is 100x, it has the longest lens so the highest power. Be careful not to crack the slide and make sure you use oil if it is an oil immersion lens.
a wet mount
A prepared slide is sealed by acrylic or any other medium. After the solvent evaporates, the specimen is locked under the slip. On the other hand, a wet mount slide has the specimen prepared just before it is put under microscope.
oil immersion
False
The oil immersion lens @100x
Press down on the coverslip
A wet mount slide is when a solution is applied to a microscope slide with whatever subject is being studied, typically under a slip cover.
The objective lens that focuses closest to the slide is 100x, it has the longest lens so the highest power. Be careful not to crack the slide and make sure you use oil if it is an oil immersion lens.
The oil might smear and ruin the slide.
your hands will burn
a wet mount
If you are using the oil immersion objective on a microscope, you must use oil to increase the resolution of the lens. These lens are used at very high magnification.
Unscrew the lug nuts holding it onto the mount. It should slide right off.
to mount the slide