0
Why should you use your turn signals well in advantage of a turn?
Wiki User
∙ 13y ago
You should use your turn signal in far enough advance so the car behind you knows you are going to turn and has enough time to slow down. However, putting the turn signal on too far in advance can be confusing because the following car will not know exactly when you are going to turn.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Why should you use your turn signals well in advanced of a turn?
To allow others [drivers and pedestrians] to know what we intend to do.
Why should you use your turn signals well in advance of a turn?
To allow others [drivers and pedestrians] to know what we intend to do.
Are the daytime running lights on a 1998 corvette wired or connected to the turn signals as well?
No. Daytime running light can be disabled without affecting turn signals.
How do you fix the signal lights on a 1988 Mercury Cougar?
Well, you don't state the poblem, but if all your turn signals are not working and flashing as they should, replace the Turn Signal Flasher Relay.
Are the headlights and turn signals connected in the 1997 Acura Integra?
Well kinda. The highbeam "flasher" function is connected to the turn signal arm.
Chevy blazer 1999 has turn signals sounds without the turn signals on?
The most likely culprit is called the "multi-function switch" located on the steering column, basically your turn signal arm. It controls your turn signals, wipers, high beams as well as cruise control if you have it. The whole unit is pretty expensive new and requires some serious labor to change it out, (removing entire dash, as well as the steering wheel and airbag unit) but it's worth it! If you are on a budget and willing to gamble, a local salvage yard should be able to set you up with one for considerably less money.
How do you tell if you need a new airbag clock spring?
The clockspring is the part that turns your turn signals off when the turn is completed or that warns you if your turn signals have stayed on too long. It also serves as the conduit electrically to activate your drivers side airbag in a crash. If your turn signals do not turn off the clockspring is probably the problem. If you get an airbag light that stays on all the time it COULDbe the clockspring but could also be something else in the circuit as well.
Why should you use your turn singals well in advance of a turn?
Why? To warn other drivers of your intention to make a turn. You want to give them plenty of time to prepare for the turn you are going to make and the sudden drop in speed of your car as you turn. Wait until the last minute to turn on your turn signals and you may be rear-ended by a driver not paying close attention or driving too fast.
How do you fix HazardTurn signals that are not working in 1995 Volvo 850 T5-R?
Well so far I have found that when I turn my headlamps on and switch to the high been and then use the rocker switch for the hazards, it will allow for my turn signals to start working again.
Turn signals do not work sometimes?
Well I personally have a 2000 Malibu LS and have had the same troubles random clicking noises when signals aren't on then no signals or random signals. The problem is your hazard relay switch, it is located in your dash board very easy abd cheap fix.
How do you fix turn signals that are not working on a 1991 Buick LeSabre?
Check for burnt out bulbs and could be a bad flasher as well.
Hazard lights dont work on 96 integra?
Well if your turn signals still work its not a short. I just fixed a pinched wire on my 96 and now my turn signals dont work. But according to a buddy of mine on Clubintegra.com there is a chance the fuse for the hazards is blown.
