Want this question answered?
When working on PC boards or any electronic equipment, heat is the biggest enemy. A low wattage soldering iron is the best because it will generate only enough heat to melt the solder and not heat up other adjacent components that are near to the point that you are soldering. Also when working on electronic equipment use a solder with a low melting point. There is a special low temperature solder with a rosin core that is made especially for PC boards. Never use acid core solder on any electrical soldering jobs.
When working on PC boards or any electronic equipment, heat is the biggest enemy. A low wattage soldering iron is the best because it will generate only enough heat to melt the solder and not heat up other adjacent components that are near to the point that you are soldering. Also when working on electronic equipment use a solder with a low melting point. There is a special low temperature solder with a rosin core that is made especially for PC boards. Never use acid core solder on any electrical soldering jobs.
When working on PC boards or any electronic equipment, heat is the biggest enemy. A low wattage soldering iron is the best because it will generate only enough heat to melt the solder and not heat up other adjacent components that are near to the point that you are soldering. Also when working on electronic equipment use a solder with a low melting point. There is a special low temperature solder with a rosin core that is made especially for PC boards. Never use acid core solder on any electrical soldering jobs.
it shouldnt.
When working on computer boards or any electronic equipment, heat can ruin the item. A low wattage soldering iron it only creates enough heat to melt the soder. Do not use acid core solder on any electrical type soldering jobs.
The type of solder that is to be used on electrical equipment should have a rosin core. Acid core solder is not recommended because it the acid gets inadvertently placed on other components, the acid will start to corrode the other components. This type of soldering usually pertains to printed circuit (PC) boards. The electrical code does not allow the use of soldered connections as it did when knob and tube wiring was in fashion. This is because of the high amperage generated by fault currents that would melt the soldered connections and open circuits that should remain closed during the fault. This is mainly to do with the soldering of neutral connections.
Make sure the soldering copper (tip) is clean and free of oxidation add some type of non acid flux and do not over heat
Acid rain causes many ill effects of acid rain to biotic and abiotic components of the earth. Acid rain erodes abiotic components and can kill or mutate biotic components.
Emery cloth and non acid type flux
It is used to clean impurities away from the surface to be soldered or brazed. Many times it is included in the flux. The use of acid type of fluxes is actually detrimental to good plumbing , soldering practices because if the flux is not properly cleaned the joint will eat away from the corrosive action of the acid
Yes, it does and acid is one of its main components
Never use a acid core solder only resin core should be used and keep the temperature of the soldering iron as low as possible 250 deg C max soldering should be done in a well ventilated space.