answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Why some engines are using centrifugal comprepressor and some engine uses axial compressor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a a turbocharger?

is a centrifugal compressor powered by a turbine which is driven by an engine's exhaust gases.


The condition that rapidly reduces the efficiency of a centrifugal jet engine compressor would be?

Pressure pulsations


What has the author A Karl Owen written?

A. Karl Owen has written: 'Comparisons of rig and engine dynamic events in the compressor of an axi-centrifugal turboshaft engine' -- subject(s): Modal response, Compressors, Surges, Gas turbine engines, Aircraft engines, Rotating stalls, Traveling waves, Fourier analysis


What is jet engine engine pressure ratio?

The pressure ratio in jet engines is the ratio of pressure between the entrance of the compressor and the exit of the compressor.


Where can you buy just air compressor engines?

Northern tools. I thInk you want an engine to power a air compressor?


Do remanufactured engines have air conditioners?

A remanufactured engine for your vehicle would not come with an AC compressor. Your original AC compressor would be reused or replaced with a new or remanufactured compressor if needed.


How does Bell Helicopter clean engines?

Bell Helicopter does not nessicarily clean engines. On the helicopters that the company owns it's mechaincs perform a "compressor wash". High pressure soap and water are run through the engine while it is turning to remove carbon and debris from the compressor blades within the engine and from the combustin chamber. Other Bell Helicopter engines owned by others are sent to facilicites authorized by the engine maker to dismantle and clean and repair the engines.


What is meant by supercharging?

Supercharging is a method of increasing an engines power output, by forcing air into the engine under greater than atmospheric pressures. Supercharging usally refers to belt driven compressor (I.E. roots/screw or centrifugal), some early uses superchargers were driven directly off the crank shaft.


What is Turbo in car?

A turbo is an air compressor that forces air into the engine under great than atmospheric pressure, there by increasing the engines output.


What is the Difference between apu and jet engine?

A typicial Auxiliary Power Unit (APU) is a turboshaftengine. It is similar to a jet engine with how it's compressor and turbine sections are laid out. However jet engines provide power through thrust (exhaust gas pressure) whereas turboshaft engines provide power through a shaft attached to either the compressor or turbine section.


Differences between centrifugal compressors and centrifugal pump?

centrifugal pump uses centrifugal action while reciprocati pump operates on resiprocating motion of pistonA centrifugal pump will typically give you a higher flow rate but a lower pressure, where a piston pump will give you more pressure but a lower flow rate.


What is bleeding of turbine?

Bleed air in gas turbine engines is compressed air taken from within the engine, after the compressor stage(s) and before the fuel is injected in the burner