0
Why the type of energy stored in water at the reservoir is different from the energy stored in water at the penstock and turbine hydrppower?
Wiki User
∙ 6y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How does falling water transfer from potential energy to electrical energy?
The water in a reservoir or lake, at a higher level than the water turbine, has potential energy. When released to flow down to the turbine it gains kinetic energy due to the movement of mass, then this is turned to mechanical energy in the turbine and finally to electrical energy in the generator
How does a waterfall make energy?
Waterfalls can be a source of energy generation, particularly hydroelectric energy, through a process that converts the kinetic energy of falling water into electrical energy. Here's how a waterfall makes energy: **Water Flow:** The process starts with a river or stream that flows into an elevated area, creating the potential energy due to the gravitational force acting on the water. **Dam or Diversion:** To harness the energy of the waterfall, a dam or diversion structure is built to control the flow of water. The dam increases the water's potential energy by creating a reservoir or headpond behind it. **Penstock:** A penstock is a large pipe or channel that directs the pressurized water flow from the reservoir to the turbine. **Turbine:** At the base of the waterfall or within the dam, a water turbine is installed in the path of the flowing water. The kinetic energy of the water causes the turbine to spin. **Generator:** Connected to the turbine is an electrical generator. As the turbine spins, it turns the generator's rotor, which is surrounded by a stationary stator with copper coils. The relative motion between the rotor and stator induces an electromagnetic field, which generates electricity through the principle of electromagnetic induction. **Electricity Generation:** The generated electricity is then transmitted through power lines to homes, businesses, and industries for various uses. The amount of energy generated depends on several factors, including the flow rate of the river, the height of the waterfall, and the efficiency of the hydroelectric system. Hydroelectric power is a renewable and sustainable energy source because it relies on the continuous flow of water in rivers and streams, which is replenished by precipitation and natural processes. It is also a clean energy source, as it produces minimal greenhouse gas emissions compared to fossil fuels.
Is a concrete dam holds back a large reservoir of water kinetic or potential?
That is potential energy when the water is sitting in the dam. The PE is converted into kinetic energy by running the water down a chute to allow it to gain speed, and then it hits the turbine blades to turn the turbine which drives a generator.
What are the energy changes that take place in a hydroelectric power station?
gravitational potential energy in the reservoir to kinetic energy in the water (when it's travel through the pipes) to kinetic energy in the turbine to electrical energy in the generator
What type of energy does the water have when it is in the reservior?
In a high reservoir waiting to go through a hydroelectric generator the water's main energy is potential energy because that is converted to kinetic energy before the water meets the turbine blades.
How is hydroelectric form?
Well, how was hydroelectricity formed. First of all people built dams in order to make a reservoir ( man made lake). All the water from the reservoir would then go down the penstock ( a water tube). The penstock would then lead into the turbine ( fan with spinning blades ) . Water would then strike the blade and cause the blade to rotate. The rotating motion would then cause electricity. The generator would guide the turbine through the way. The electricity would then get sent through the power lines.
Why is the runaway speed of a hydraulic turbine always kept twice its normal speed?
The runaway speed of a hydraulic turbine is the speed at which the turbine coupled to the generator runs at the maximum possible speed due to loss of load and this happens until the shut off valves completely closes the discharge from the penstock. the runaway speed of the turbine is determined by the turbine designer and is influenced by the maximum discharge of water from the penstock, the combined inertia of the turbine runner and the generator and the flywheel. this factor can vary from 1.5 up to 3 times the nominal speed of the turbine and is determined by the turbine designer considering all the load parameters.
How does the water turbine do what it does?
Water traels thru a pipe called a penstock then hits a turbine and the force makes the turbine spin. The energy created travels thru copper coil and goes to the generator. the water meanwhile goes to the river
What is hydro power plant reservoir?
it is energy regeneration power plant in which water is used to generate power.water is moving on turbine and then turbine moves so energy stored in the resrvoir yhat is called as hydro power plant reservoir.
How does the water get cleaned from the reservoir to your house?
the turbine that in the generator of the dam takes all the dust out of it.
What is a different between the turbine and genetrators?
A turbine drives a generator.
What is main inlet valve used in hydroelectric power plant?
Main inlet valve or shortly we say MIV is the spherical valve which installed before water enter into spiral casing of the hydro turbine.Water from the dam go to the penstock and before water enter the turbine, MIV is a component in between stop the water for small maintenance purpose in the turbine hall
How does falling water transfer from potential energy to electrical energy?
The water in a reservoir or lake, at a higher level than the water turbine, has potential energy. When released to flow down to the turbine it gains kinetic energy due to the movement of mass, then this is turned to mechanical energy in the turbine and finally to electrical energy in the generator
Describe an oil and natural gas reservoir that might be found beneath an impermeable rock layer?
the generator spins and the turbine help i keep the steam
What are the different types of Turbines used in hydroelectric power plants?
1 Pelton Turbine 2 Kaplan Turbine 3 Francis Turbine 4 Propeller Turbine 5 Tubular Turbine
What are the different kinds of turbine blades?
pine tree
Where does hydroelectric power come from?
What is hydroelectric power?Water is needed to run a hydroelectric generating unit. It's held in a reservoir or lake behind the dam, and the force of the water being released from the reservoir through the dam spins the blades of a turbine. The turbine is connected to the generator that produces electricity. After passing through the turbine, the water reenters the river on the downstream side of the dam.My father used to work at Amoskeag Hydro in Manchester, NH when I was growing up.If the Dam cracks and smashs down to rubble then the town its generating energy is about to have a flood :)
