A three-phase meter can be used for single phase while the reverse is not the case.
Compared with what?
Phasing, or the number of phases in an electrical system has nothing to do with the voltage. A single phase and three phase supply could have a voltage supply of any given voltage from virtually 0 to infinity. Most single phase power supplies in the US are 120/208-240 volt. Three phase power supplies are typically 120/208 to 277/480 volt.
You need to match the UPS to the service. If it is three phase you need a three phase UPS, and vice versa for single phase. It isn't a case of being better, it is a situation where you need to match your application.
One is just as safe as the other. The deciding factor here is what supply voltage do you have at your establishment to operate the welder a single phase or three phase service.
single phase, double phase & three phase
The difference between a single phase and a three phase motor is the amount of power conductors that feed the device. As to the other part of the question a three phase motor will not start or run on single phase. The phase angles on three phase are 120 degrees apart on a single phase system they are 180 degrees apart.
No. For three phase, you need a minimum of a two element meter.
Phasing, or the number of phases in an electrical system has nothing to do with the voltage. A single phase and three phase supply could have a voltage supply of any given voltage from virtually 0 to infinity. Most single phase power supplies in the US are 120/208-240 volt. Three phase power supplies are typically 120/208 to 277/480 volt.
Two single phase meters are not needed. A three phase meter is manufactured and is used when installing a three phase electrical distribution.
The reading on the 3-ph meter would equal the sum of the three separate readings on the single-phase meters. The neutral sides of the single phase meters do not need to be connected to the neutral wire as long as they are connected together.
A 3-phase meter measures the sum of the power in the three phases, so if power is drawn on one phase only it will still be correctly measured.
You need to match the UPS to the service. If it is three phase you need a three phase UPS, and vice versa for single phase. It isn't a case of being better, it is a situation where you need to match your application.
Yes, there is a difference between single phase and three phase circuits.
There is no such thing as a two phase instrument. There is only single phase and three phase. You can only have: single phase/ one pole single phase/ two pole three phase/ three pole
One is just as safe as the other. The deciding factor here is what supply voltage do you have at your establishment to operate the welder a single phase or three phase service.
single phase, double phase & three phase
Any load that needs three legs from a three phase system can not be considered single phase. Single phase from a three phase system only needs a connection to two legs.
No A intermediate switch can not be used to change three phase to single phase.