answersLogoWhite

0


Best Answer

single phase, double phase & three phase

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are the three types of phase on its final phase?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

What is the difference between a one phase and a three phase motor. And if a three phase motor is given a single phase supply will it run or not?

The difference between a single phase and a three phase motor is the amount of power conductors that feed the device. As to the other part of the question a three phase motor will not start or run on single phase. The phase angles on three phase are 120 degrees apart on a single phase system they are 180 degrees apart.


What is static Phase Converter?

A phase converter converts single-phase, alternating current power to three-phase power. There are two general types, static converters and rotary phase converters. A basic form of rotary phase converter is a single-phase electrical motor with its shaft coupled to a three-phase alternator. A static phase converter converts single-phase power to three-phase power by using electronic switching. They typically convert the single-phase, alternating current to direct current and then electronically synthesize three phase power output for use with three-phase equipment.


How does a two-phase system differ from a three phase system?

A two-phase system is archaic and you are unlikely to find it in use anywhere these days, so it is mainly of historical interest. A two-phase, three-wire system, consists of two phase voltages, displaced from each other by 90 electrical degrees, and a phase voltage which is 1.414 x phase voltage.A three-phase system consists of three phase voltages which are displaced from each other by 120 electrical degrees. In the case of a three-phase, three-wire, system, the line voltages are numerically equal to the phase voltages; in the case of a three-phase, four-wire, system, the line voltages are 1.732 x phase voltage.


Is there a difference between three phase and single phase electrical supplies?

Yes, there a difference between three phase and single phase electrical supply services.


Why three phase meter is better than single phase meter?

A three-phase meter can be used for single phase while the reverse is not the case.

Related questions

What is the need of single phase to three phase conversion?

There is no need of single phase to three phase conversions. Both service types are available from the local utility company.


What does one mean by 3-phase loads?

Electrical circuits are designed in two phase types. Either single phase or three phase. A single phase is one wave of electricity while three phase is three waves that are offset.


What is the final phase of alcoholism?

It's a myth that there is any "final phase" of alcoholism.


What is the final and shortest phase and interphase?

G2 phase


Where can you find a single pole triple throw mini switch?

These types of switches are usually found in three phase installations. When breaking line voltages in a three phase system all three hot legs must be opened to isolate the equipment. These types of switches come in different types for specific uses. Molded case breakers for circuit conductor protection. Non fused switches for equipment transference and fused switches for three phase service entrance equipment.


Three substages of interphase?

G I = growth phase. S = synthesis phase ( DNA replication ) G II = the second and final growth phase before mitosis.


Is menopause a phase of the menstrual cycle?

Yes it is the final phase


What is a disconnect installation fault?

I have never heard a fault type referred to as a "disconnect installation fault". In general there are a few types of faults - phase to ground or ground faults, phase to phase, phase to phase to ground, three phase, and three phase to ground. I'm guessing what you're referring to is a fault on a disconnect switch. Disconnects are used to isolate equipment. When a disconnect faults, it usually faults to ground.


What are the types of faults in ehv transmission lines?

The three types are Line to ground faults line to line fault double line to ground fault three phase line to ground fault


The final phase of mitosis is-?

The final phase of mitosis is called Telophase. The other stages are Prophase, Metaphase and Anaphase.


Two phase instruments?

There is no such thing as a two phase instrument. There is only single phase and three phase. You can only have: single phase/ one pole single phase/ two pole three phase/ three pole


Single phase and three phase circuit?

Yes, there is a difference between single phase and three phase circuits.