0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What can a pillar drill cut through?
A pillar drill can cut through almost any material if the speed is correct and the appropriate drill bit is used.
What is the analogy of drill to bore?
knife to cut
What colored drill bits drill through cement?
The colour is irrelevant , that just depends on the manufacturer. To cut through concrete you need a 'carbide tipped' drill bit. This tip is a little wider than the drill bit and is quite obvious.
Why do synchronous motor have unmeasurable slip?
Synchronous motors have unmeasureable slip because they stay in sync with the input line frequency.
Why is diamond used in drill bits?
Diamonds are widely used in the tool industry to tip drill bits and to edge blades that cut tile, stone and rock.
Can drill cut through glass?
An ordinary HSS drill bit can not cut through glass. A diamond tipped drill bit is necessary for this.
A can be used to cut a round hole in wood?
you can cut a hole in wood using a special drill attachment. alternatively you could drill a hole then cut a hole with a jigsaw
What can a pillar drill cut through?
A pillar drill can cut through almost any material if the speed is correct and the appropriate drill bit is used.
How do you remove the hydraulic line from the transmission?
in the clutch kit u get a easy disconnecter tool that u slip in between the plastic slip guard and the metal piece and pry up don't cut the line hard as hell 2 find
When is the drill bit most likely to catch when drilling through stock?
drill bits are most likely to slip when drilling through tiles or stock.
What is the analogy of drill to bore?
knife to cut
What size drill bit should you use to drill a hole that is threaded for a 1by4-20 UNC bolt?
Your meaning is not clear. - If you are going to tap the threads in, use a 7/32 drill bit. If you want a hole that this bolt will slip through, use a 9/32 drill bit.
What jobs does a drill press do?
The Drill Press is used for drilling holes in various materials.
What is the drill size for 8-32 sti tap?
For a cut tap the correct drill size is a #17 drill, which has a diameter of .173 inches.
After how much cumulative ton mile we should slip and cut the drilling line?
depend on wire specifications...... in case of 1 3/8'' .....from 1900 to 2100
Can a drill cut through a hockey puck?
Yes.
What song did Joe Jonas slip and cut his hand in?
SOS
