0
What else can I help you with?
How much does a Cummins ISX 13 engine weigh?
The Cummins ISX 13 Weighs 2940 Lbs.
Your car wont crank what can this be?
Dead battery, disconnected starter cable, or the engine is missing.
92 Geo Tracker still won't start?
wont crank or wont start http://www.kick-fix.com/nostart.html if it wont crank backup 1 page find no crank.
How does car act when engine seizes?
it stops running motor wont crank or even move should have 0 compression to.
Your 1992 cadillac deville wont start whats the problem?
First you need to give a little more info.Will engine crank or not, is engine getting fuel.
Where is the crankcase pressure sensor on a cummins isx engine?
In crankcase filter box
Where is thermostat located on cummins isx 400?
Upper front right portion of the engine.
Where is the thermostat on cummins isx 435 located?
Upper front right part of the engine.
What type of coolant do you run in an 05 cummins isx 400st engine?
Red ELC.
Why if a 2002 Passat has a good battery will it not start?
there are several reasons your car will not start. first does it crank? if not you have a neutral safety switch problem.this makes sure you are in park while attempting to start the engine. Since you mentioned the battery i can assume the engine does not crank. If you have an alarm there is a relay inside the alarm box that keeps the car from starting unless it is disarmed. this relay can go bad and after you disarm the alarm in does not make,keeping engine from starting. Please be more specific whit what the engine is doing or not doing.big difference from wont start to wont crank.
Why wont your Chevy truck crank after you just had your oil changed?
"Crank" meaning the starter doesn't crank the engine over to start it, changing the engine oil should have nothing to do with it not starting. If the battery was weak and something was left on, it may have run the battery down. Also check the engine oil level to be sure they put new oil back in or possibly left the drain plug loose and the oil drained out. If the engine was run with no oil in it, it could have seized the engine and it wouldn't crank over, in which case the engine is ruined.
Will a yz 85 crank and rod work in a yz 80 motor?
No it wont due to the keyway location which knocks out the timing. The crank will fit into the 80cc engine but you will battle with the timing which will run the engine in reverse. The 85cc conrod and big end pin fits the 80cc crank
