0
Why won't my 94 Chevy 1500 not crank when hot after 3 - 4 previous cranks OK. I replaced starter battery alt plugs. Replacing starter worked for a while. Checked and clean some grounds. Thoughts?
Wiki User
∙ 12y ago
Could be the coil. I suspect that it is the ditributor module. This sits in the distibutor cap where the wires hook up (not plug wires). These have tendency to go bad especially the factory ones,
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
When does timing belt need to be replaced on 2003 volkswagen jetta?
60,000 miles you should have it checked to see if it needs replacing.
Why does a 1992 Olds Ninety-eight stall after it has been driven awhile?
have your oxygen sensor checked or replaced. we had the same issue on ours and replacing the o2 sensor fixed the problem
Does the radiator have to be replaced when replacing the engine?
If it is clean, undamaged, and in good working condition.....NO. Since the radiator needs to be removed, to remove the engine, now is a good time to have it cleaned and checked.
How can an inequality be checked?
By replacing a number for the variable.
When replacing a new wheel hub do you have to replace the steering knuckle?
Not necessarily. If there is play on the knuckle, then you should have it replaced,or at least checked by qualified person. The fact that you ask, means you shouldn't be under the car in the first place.
What should you do if you replaced brake pads and calibrators and still severe vibration occurs?
You should have your rotors checked and possibly turned or replaced as necessary You should have your rotors checked and possibly turned or replaced as necessary
Why does a 1990 Toyota 4 runner get hot when the heads were resurfaced and radiator was checked and it has a new thermostat and belts and headgaskets and heating element after blowing the headgasket?
You've checked and replaced everything except for the water pump...I recommend replacing the water pump every time you replace the timing belt.....
What four things should be checked before placing the computer in the abs?
The 4 main things that need to be checked and or replaced before replacing the computer with an ABS system are the pads, the rotors, the calipers, and the shocks. Also make sure to look over the brakes as well before putting in the ABS system.
My 1989 jeep wrangler turns over but does not start and the coils have been replaced and the wiring has been checked.?
The timing or crankcase sensor needs to be checked and most likely replaced.
You have 1995 Honda accrd sedan and you replaced battery after replacing battery car stereo does not turn on you checked fuse and fuse is fine any ideas what can be wrong?
You must insert the 5 digit code in order for the radio to work.
What does tune up mean?
A basic tune-up would involve replacing the spark plugs and possibly the plug wires. The fuel filter may be replaced and all fluid levels checked. Before electronic ignition systems it also meant to replace the points, rotor, condenser, and inspecting the distributor cap.A basic tune-up would involve replacing the spark plugs and possibly the plug wires. The fuel filter may be replaced and all fluid levels checked. Before electronic ignition systems it also meant to replace the points, rotor, condenser, and inspecting the distributor cap.
I have a viberation in my 2000 buick lesabre I have checked everything in the front and rear put new tires on and re-balanced them happens from about 45-70 then goes away any thoughts?
this could be your brake rotors are warped. i had this problem and replaced the rotors and then it was fine.
