transmission stack in limp mode need to replace input or output sensor
Have the trans computer checked for codes. There are a dozen other things that can cause it not to shift.
If a 1995 Nissan Sentra will not shift out of first, there could be a problem with the throttle valve cable. The transmission could also be damaged.
The shift link cable could be broken, or the 1st/2nd shift fork, inside the transmission, could be damaged.
The first Chrysler Sebring was a Coupe (hardtop) & was released in 1995, the Sebring Convertible didn't get released until the following year - 1996.
yes
It is mounted on the top rear of the transmission bell housing.
you dont have to but it makes it a lot easier.
The only dipstick are for the engine oil and automatic transmission fluid.
Because you don't have enough the transmission fluid in the system.
This is part of the neutral safety / transmission shift location switch / back up light switch. It is mounted on the transmission behind the shift sector shaft. The shift cable will run from the shifter to the transmission and this switch is mounted there on the side of the transmission.
The most common problem for the 1995 Cougar xr7 Transmissions is the shift selenoids and the TCM Transmission control modules needing to be reprogramed common fixes for the shift control module would be a transmission overhaul or replacement do to the fact of the shift control module is located inside of the transmission and as well another cost effective fix is to get the transmission control module reprogrammed.
Check the transmission fluid on the 1995 Nissan Altima. Bad fluid can cause the transmission to shift harder on parts that are more worn.
5-w30