0
possible siezed linkages or motor. common for linkages to get siezed,
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Windshield wipers wont turn off?
A bad relay switch will cause the windshield wipers to not turn off. Replace the relay switch and the windshield wipers should turn off.
How do fix your windshield wipers on your Mazda Protege?
i put a new windshield wiper moter in and the fuses are fine but my wipers still wont work
Why wont my windshield wipers turn off?
There are a few different reasons why your windshield wipers may not turn off. You may for example having an electrical issue within the car.
Why wont the windshield wipers shut off in your 2004 cadillac cts?
because it doesnt work
Why wont your manual 2000 Hyundai accent budge when you hit the gas?
The E brake is on?
1993 ford f150 windshield wipers wont work?
The 1993 Ford F1 50 windshield wipers to stop working. The fuse can be found in the fuse box. The location of the fuse is listed on the inside cover of the fuse box.
What is wrong with Ford Ranger XLT Wipers?
My windshield wipers wont work, I have looked at the fuse but it is ok. sounds like a relay cliclking under the dash, where is it located?
How do you fix windshield wipers that wont move after they tried lifting snow on 99 Ford F150?
Your windshield wipers were most likely overloaded and blew the fuse, try replacing the fuse. If that does not fix it then it is possible that the wiper motor burned out and will require replacement.
Where can you find a 1994 s 10 windshield wiper wiring diagram?
If your wipers aren't working then check the grounding screw under the hood if it becomes loose your wipers wont work.
Why wont my windshield wipers go down on my 1998 crown vic?
I had the same thing on my 2000 Crown Vic PI and it was the motor.
Why wont windshield wipers work on vw jetta?
maybe the motor is burn..... maybe the motor is burn..... maybe the motor is burn..... maybe the motor is burn.....
Why wont your windshield wipers work on your 99 voyager if the switch is good and when you manually trip the relay the motor works fine?
Bad ground? Bad relay?
