your low on blinker fluid.
The seal is shot, time to replace the water pump. Do not let engine over heat!
That means it time for a new blinker light it is burned out.
if you sit in the left lane for a long time the blinker will automaticly turn on
I have an '86 Chevy S-10. The wiper, blinker, dimmer, and cruise control are all in one switch. The cruise wires are threaded through the hollow shaft of the blinker arm and come out through a slot just inside the column cover. I recently replaced this switch because over along time of using the blinker, dimmer, and wipers, the wires had frayed through where the cruise wires come out of the blinker arm. Have a friend who is good at mechanics inspect the wiring and see if this is the problem. Replacing my blinker arm from a junk yard will solve my problem for a little while.
In one weekend by a backyard mechanic or small shop ... NO.With a lot of time/money and chopping the engine bay down to nothing ... YES.
change the bulb
there is probably a short in one of the circuits or else somehow two wires were crossed that shouldn't be
Check the coolant level and make sure that its full, and is not leaking down over time. If the system is full then the low coolant sensor is probably bad.
Press both blinker directions at the same time.
Been told when a computer is replaced, with a new one it must be flash tuned, set, adapted to your car. Chevy agency told me this, plus they also said theres time you will have to replace it with 3 or 4 to get one that works right on a particular car, I'm fighting the same thing but mine will start, just wont go, dies when put in gear.
The started on a 1996 Chevy S10 4 cylinder is located under the battery and to the right. With the right tools and time it is not hard to replace.Ê
Fuel pump should run for about 2 seconds every time you turn the key to the RUN position. That re-pressurizes the fuel line. Normal operation.