0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Yamaha yzf600 bike won't idle unless choke is on why?
i had the same problem and it was just that the idle screw needed to be adjusted. its on the right side of the bike and its a little knob that you can turn with your fingers. Start the bike with the choke on and let it warm all the way up and then adjust the knob clockwise to make it idle faster until you can close the choke all the way
What could be causing your 2002 Yamaha Raptor not to want to run or idle correctly?
clean the carbs
Had starter clutch replaced on my Yamaha v star classic 1100 now it runs bad and want idle I cant ride it.?
Cams out of time.
Why does a 1998 Yamaha yzf 600 not want idle without the choke on?
time to rebuilt carbs. when you choke a motor of any kind what you are doing is cutting of the air so the motor pulls more fuel. so this meaning that when you turn choke off not enough fuel is getting to the motor.
Why does my 83 yamaha max 750 idle high as soon as you start it?
Does it idle high all the time or just for a bit after you start it? There are a couple things you could check such as: 1- Defective throttle cable 2- Idle srew on you carburator is set too high 3- Choke is on Good Luck!
How do you set the choke and idle on a 1986 s-10 blazer?
That vehicle is throttle body fuel injected, there is no choke or idle adjustments. You have other issues such as a large vacuum leak causing your idle problem.
How do you get the idle down on a Yamaha badger?
To bring the idle down on a Yamaha badger is really easy. All you have to do is adjust the fuel settings on the carburetor.
Should you drive a motorcycle with the choke out?
No, only use the choke until the bike can idle without it
What causes a truck to idle high when started?
the choke is on
Why will my suzuki Ozark not idle when hot?
you choke may be on
Rapter80 atv will not idle on its own choke needs to be on?
there should be an idle adjustment on the right side of it
Where is the idle screw for a 1988 rm 80?
well it depends on whatcarberator you have on it if yours have the choke on the side that you pull up then you idle it by turning the choke after you pull it up if your choke pulls out from the side then look on the right side of the carb and there will be a screw on the right side turn it too the right to get it to idle hope i helped
