If the battery is good and the starter is good, then you must have a wire disconnected somewhere.
starter solenoid is on the inside of the fender twards the cab from the battery follow the positive battery cable at the end will be the solenoid
These answers by mechanics about dead batteries are amazing me. I am a girl...really into cars because I have had a few. I just had this problem in my 1989 classic Saab. The problem is your starter...The clicking sound means that the pin inside of the starter is not projecting itself and thats why when you turn your key you hear a clicking. Get your starter tested
Transitors
If the starter is clicking when you turn the key then the relay is not the problem, more likely is the battery and starter wire connections. Take them off and clean them before putting them back on ( have the battery checked ) corrosion will cause the symptom you described, however there should be a starter relay in the engine compartment fuse panel. If the truck is a standard transmission, it could be the Neutral safety switch, which is located under the clutch pedal. However, most likely it is the solenoid on the starter, I just had the same problem, time for a new starter.
ignition module is inside distributor along with hall sensor
there is no relay for the starter. there is a solenoid (switch) and ignition switch. the solenoid is part of the starter (small cylindrical shape above starter housing. the solenoid has the battery and ignition connections). and the ignition switch is where the car-key goes. you need at least 8v from the ignition to the solenoid for the starter to operate. use a multimeter. otherwise check your starter - battery connections. otherwise replace the starter. otherwise, take off the starter and inspect inside the starter housing. if the starter is clicking but not turning the engine the starter teeth aren't engaging with the teeth on the flywheel. get a manual to the car here: http://www.germanautoparts.com/Books/Volkswagen
The battery on a 2002 Chrysler Concorde is inside the right front fender.
The battery on a 2013 Chrysler 200 is inside the left front fender.
my ignition is broke and on the on position how can i bypass the ignition n use a toggle for power and a pushbutton to start run thik power wire from positive of battery to starter. then wire from starter to distributer. then run wire inside or vehicle to push start and ground it or run back out to battery to neg. put toggle switch some where in the process to kill it.
The battery is inside the driver side fender.
The battery is inside the driver side fender, in front of the tire.
The battery is inside the driver side fender in front of the tire.
The battery is inside the fender, in front of the driver side tire.
The 2004 Chrysler Sebring starter fuse can be found in the fuse box. The location of the fuse can be found on the inside cover of the fuse box.
It is inside the driver side fender.
On the 2.5L V6 it is built inside the distributor.
The battery is in front of the left front tire, inside the fender.