0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Layout of fuse box on Ford Mondeo p reg?
My P reg mondeo wont start, there seems to no power at all when I tune the key. what can I do?
Your mondeo wont turn over could it be the immobilizer?
NO
Why wont the radio work after changing the battery on a Ford Mondeo?
You need to find the security code, (usually written down on the handbook somewhere) and input the code its usually 4 numbers.
Your 2007 Ford Mondeo you drove into river wont start now?
Yeah, because you drove it into a river, flooded the engine most likely, fired the electrics...and basically destroyed the car. Good going.
You opened the car door and alarm and hazards wont stop goin off the car is 1998 Ford Mondeo?
You could try putting the key in the ignition and starting it should stop the alarms andcheck the battery in your remote.
Is there a trick to turning the retaining ring when replaceing the headlight bulb on your 1997 Ford Explorer It just wont budge?
No, just as long as you are turning it counter clockwise when standing behind the headlight.
Why wont your speedometer work on your peugeot 306 even though you have replaced it?
you replaced speedo, so try replacing speed sensor
Your ford freestar wont start?
2007 ford freestar
Interior lights wont dim on my mondeo?
If your interior lights are dimming, either your battery or starter could be failing. You should have your car checked.
How do you stop a 2001 Toyota Echo digital odometer?
First of all, it is illegal to do so. Secondly, the only way is to disconect the speedo sender, which obviously also stops the speedo so you wont know how fast you are travelling, but that will stop the odometer.
How do you fix 93 s10 blazer Transmission wont shift into 3 or OD speedo gauge not working?
93 tranny is electronic if your speedo isn't working it won't shift into 3 or OD. Your speed sensor is more than likely the problem.
How do you back up the piston in the caliper on the rear brakes of a 2002 X-type?
AnswerSometimes if piston wont push back in try twisting it back in. Its on a 'staircase' pawl. Twist. push, twist, push etc.Use a 12mm (about 1/2inch) hex key to rotate the piston at center hole. no need to push, just rotate. Before rotation don't forget to let the handbake off, and brake fluid reservoir open.Check the piston gaskets and replace if needed (Ford Mondeo MK3 compatible), the set for the Ford Mondeo is about 11$ per caliper.
