there might be a short in the transmission wiring that might have happened when you swapped out the radio
if it's stuck in third gear, that's probably the issue
The gear shift lamp on a 2006 Toyota Corolla can be replaced by taking apart the gear shift plate and replacing the bulb. This can be a very complicated procedure. The top of the gear shift plate is held on by clips at the front and back.
Usually, the complete cable must be replaced.
If your speedometer isn't working then that gear needs replaced before it'll shift
you have burnt out the 3rd. gear and overdrive. you will have to have it rebuilt or replaced.
The main problem with any vehicle that will not shift out of gear deals with the transmission. This is a problem where the transmission may need to be replaced to fix it.
transmission needs to be rebuilt or replaced, sorry
most likely you need the clutch paw replaced in the tranny.
its the bitsi cylinoid in your gear shift which allows u to take the car out of park when u engage the brake u need to replace your gear shift assembly i just replaced mine 400 bucks
What are the two d's on the gear shift for>
Do you mean that the car will not shift into first? The clutch is the left pedal on the floor and should work independently of which gear is selected. If the car will not shift into first the clutch may need to be replaced, transmission synchros or gear teeth for first gear could be damaged(chipped,missing or broken) or the shift selector shaft might need to be realigned and/or have it's bushings replaced.
bleed your clutch..that may be the problem
Yep, then shift from second to third gear.
A bad solenoid is likely the reason why your 1994 Chevrolet S10 Blazer won't shift into 1st or 4th gear. Getting it replaced should fix the issue.
truck start shift is hard to move in gear
No thanks, I do not want to shift to 3rd gear or drive.
700r4 gear shift lever want lock in place
The shift cable has failed.
The synchronizers in the transmission are bad. If the gears grind when trying to get it into 1st or 2nd then it's probably the synchro's. If you just can't get it into gear then the 'shift rod bushing' or the "shift couplers" are worn. They are under the gear shift inside the shift tunnel. If you don't know if they have been replaced or not they probably haven't been. Buy the Bentley manual and it will walk you thru it.
I just fixed a 2002 Dodge Neon that would not shift up it was stuck in low gear replaced TCM now trans is working fine
My 1998 Nissan sentra wony shift into high gear
The 3-4 shift fork in the transmission is bent and will have to be replaced. GM came out with a steel fork that replaces the original aluminum shift fork.
light is out in the gear shift area between the seats,how can I change it?
i have a 1998 honda accord the gear shift is locked...
I had a similar problem where it would shift into reverse or drive but not go immediately. Or sometimes it would drop out of gear and you'd have to rev up to get it to fall back into gear. i replaced the transmission filter and it fixed the problem.