0
Why would a 1989 corvette have no injector pulse after changing the distributor module and the ECM Fuel pressure45psi. There is power to both injector wires with ignition on but no pulse.?
Wiki User
∙ 14y ago
Try changing or checking the oil pressure switch next to distributor if it goes bad the engine will not fire or start. Motor (ECM) has to see at least 3 psi of oil pressure to start. And will also shut down if less than 3 psi.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the ignition module 1984 Corvette?
The ignition module is located in the distributor under the rotor, it plugs in.
Where is the ignition module located 1984 corvette?
The ignition module is located in the distributor under the rotor, it plugs in.
Why my Corvette will not start after flushing out the engine block?
wet ignition need to know the year but if the distributor is the opti spark syst a cup of water will cripple this system
What is the firing order 1973 Corvette with points ignition?
The firing order for a 1973 corvette 350ci and the optional 454 is 18436572 Firing order remains the same for breaker point ignition as well as HEI electronic Position of #1 plug wire on distributor cap changes slightly when converting to HEI from a standard breaker point ignition system...............sfvrider242
How do you change the distributor on a 1994 Chevy Caprice Classic?
All 1994-96 vehicles, use a new distributor ignition system which was originally developed for use on Corvette. The new system known as the Opti-Spark ignition system consists of a distributor assembly which is mounted on the front engine cover, under the water pump assembly, control circuitry an external coil. I the Opti-Spark system, all ignition timing is controlled by the PCM based on signals from the distributor
Will an HEI distributor fit your 1972 corvette?
Yes, but you will need to remove any ballast resistor or resistance wire going from the ignition switch to the + side of the coil and replace it with copper.
What is the ignition timing for a 1977 corvette 350 LS?
The 1977 Corvette 350 LS has ignition timing standard in this model. The purpose of the ignition timing is to help start the car in synchrony.
How do you remove the ignition switch on a 1989 Chevy Corvette?
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
How do you replace the ignition distributor on a 93 mx6 v6?
How do you replace the ignition distributor on a 93 mx6 v6 pics?
Where is the ignition control module located on a 1981 corvette?
It is located underneath the distributor rotor. It is fastened down with two screws in the distributor housing. For the best access to it you will need to remove the following: spark plug wires from the distributor cap (be sure to label them for correct re-installation), distributor cap and distributor rotor.
How do you replace a 1975 corvette ignition switch?
== ==
How do you repair trouble code36 on 1993 corvette?
Code 36- Distributor ignition system. Faulty high resolution (360X) pulse or multiple low resolution pulses detected. Check pigtail connector from distributor to main harness for any opens or shorts. Verify wiring is okay before replacing distributor.
