An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.
Where is the control module located on the 1983 Chevy blazer
Inside the voltage regulator on the alternator.
your a fatty
The alternator is failing.
There is 1 per cylinder.
It will not run if you bypass the ignition module (no spark).
change the alternator batteries
The voltage regulator is built into the alternator.
The ignition module is located in the distributor, under the distributor cap.
Remove the alternator belt by loosening the tensioner pulley. Remove the wiring from the alternator. Remove the retaining bolts to the alternator. Reverse the process to install the new alternator.
It depends on what year S10 you have.
did you check your battery and alternator?
You will need to remove the retaining ring at the top of your 1978 Chevrolet Blazer ignition switch. Slide the ignition barrel out and remove the wiring harness. Reverse the process to install the new ignition switch.
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
mounted next to the ing coil on the same bracket
this site will help
A faulty alternator, a faulty belt tensioner.
Yes, as long as they have the same engine
Depending on what type engine you have, the ignition module may be an integral part of the distributor cap.
check emc fuse and the fuse next to it
Generally you would need to have a replacement alternator which is only around $60 and it is refurbished but a 1999 Chevy Tahoe alternator should work just as well
The 2001 Chevy Blazer does have an ignition security system that is controlled by the computer in the vehicle. The light might come on because of an error that is coming up in the computer due to a key problem or an ignition problem. This is a common issue with the 2000 and 2001 Blazer.