My 1996 Town and Country did this and it was the Cam Shaft Sensor. The check engine light came on also. Went to Auto Zone and they read code. It was easy to change and less than $50.
It could also be a simple problem as the fuel filter.
There is no valet mode on a 1996 Chrysler Town and Country.
A 1996 Chrysler Town and Country does not have a kill switch.
The fuel injectors are self bleeding on a 1996 Chrysler Town and Country.
how to reset the antitheft alarm system in a 1996 Chrysler town&country lxi
A 1996 Chrysler Town and Country has two oxygen sensors. They are screwed into the exhaust on the rear of the engine.
The oxygen sensors on a 1996 Chrysler Town and Country are screwed into the exhaust system behind the engine.
No.
No, Chrysler does not use inertia switches.
A 1996 Chrysler Town and Country does not have a speedometer or odometer cable. That signal comes from the transmission output speed sensor.
The spark plug gap on a 1996 Chrysler Town and Country is .050 inch.
Bad gas, fouled plug(s), engine out of time, vacuum line leak or clogged.
A 1996 Chrysler Town and Country uses DOT3 brake fluid.