my hum was solved by cleaning the K & N filter i use. the air flow was restricted and the engine was pulling air past the seal. if you use a disposable air filter, replace it. also check for foreign debris anywhere along the intake path and remove it.
In a 1997 Ford Aerostar : Refrigerant 134a is used
There are ( shock absorbers ) on a 1997 Ford Aerostar ( front and rear )
need to replace the intake manifold gasket
For a 1997 Ford Aerostar : ( 21.0 U.S. gallons / 79.5 litres )
On a 1997 Ford Aerostar : The fuse box is under the instrument panel , on the drivers side
1997 van aerostar front heater blower guide
On a 1997 Ford Aerostar : The fuse box is under the drivers side of the dash
Will a 1997 Aerostar transmission fit in a 2000 ford ranger?
Ford stopped making the Aerostar in 1997
It could stall if you use the rear brake while going downhill. Is this the case?
The 1997 Ford Aerostar oxygen sensor is screwed into the exhaust pipe. It is about even with the rear of the oil pan.
Too the best of my knowledge, no. The 1991 used a sealed beam and the 1997 used a halogen type.
On a 1997 Ford Aerostar 4.0 ( and 3.0 ) The engine cylinder locations are numbered : 3 - 6 2 - 5 1 - 4 front of Ford Aerostar
If a 1997 Ford Aerostar surges when low cruising the throttle body may need to be cleaned. There could also be a lose hose or one that needs repairing.
in the owners manual
It's a 1997 Tahoe
It sounds like you need a new serpentine fan belt.
On a 1997 Ford Aerostar , 4.0 ( and 3.0 ) 3 - 6 2 - 5 1 - 4 front of vehicle
try replacing mass air sensor
According to the 1997 Ford Aerostar Owner Guide : ( Motorcraft MERCON automatic transmission fluid is used as the power steering fluid )
The Ford Aerostar is a van that was produced from 1986 to 1997 by the Ford Motor Company. They produced 2,029,577 Aerostar vans in that time. This model was replaced by the Ford Windstar.
The 1997 Ford Aerostar ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Have motor mounts checked.AnswerYeah, it's most likely the motor mounts, I had mine replaced, it was also vibrating when the heat or a/c was on. it could also be the flex tube
Remove the battery cables. Remove the battery tiedown. Remove the battery from the Aerostar. Reinstall in reverse order.