sometimes the spring on the clutch plate breaks off and will not engage fully to the flywheel or the pilot bearing is sticking not moving freely
I had this happen to me on a suzuki sidekick 1989 could not put into gear while engine running
but could when the engine was off ,testing by putting it in first gear and starting engine
while putting my foot on the clutch pedal ,,will work but if you can no change to seconde gear then you have a broken spring in the clutch area,, hope this helps
You need to see a gunsmith if it isnt working properly.
You might check the wiring of your speakers and check if they are working then check your CD player if its working properly.
how to unlock a Hyundai tv my unlock button on my remote isnt working
if the hubs are working properly all u do is shift transfer case back to 2WD if hubs are not releasing you will have to check the hubs best idea change the auto hubs for warn manual locking hubs
It will keep the temperature within pre-set limits if working properly.
it is ok to continue driving the vehicle while the catalytic converter is not working properly?
To check if RTD PT100 is working properly you need to check and make sure all the wires are connected. Take several readings and if they are the same, it is working properly.
Not sure what engine you are working on but sometimes you can roll the engine backward and get the gear to disengauge .
You may have a bad output sensor or the wires are loose on it. the output sensor is located behind the air mixture box. to remove it you will need a 10MM wrench and about 30 minutes.
The wiper motor may not be working properly or the combination switch may also be not working properly.
A properly working cat, no. Removing it, no. A failed cat, yes.A properly working cat, no. Removing it, no. A failed cat, yes.
disengage means to abruptly stop a plan or mission, or stop or pause a mechanism from working. example: "Disengage landing!" ...Is what a pilot might say in his radio com to other planes if there is danger on the landing grounds.