Dodge Grand Caravan
Toyota Camry
Windows XP

Why would a Camry rattle when you release the pedal at start?

121314

Top Answer
User Avatar
Wiki User
2005-02-11 04:00:24
2005-02-11 04:00:24

If it's coming from the rear, I would check either your catalytic converter or your muffler. Either could have pieces loose in them that would cause a rattling sound when you either push or release the throttle.

1
馃檹
0
馃え
0
馃槷
0
馃槀
0

Related Questions

User Avatar

on 1998 Camry turn key on push and release alarm button turn key off then start

User Avatar

Key in the ignition, Push the clutch pedal all the way in, turn the key until engine starts, then release key and then release pedal. who said it was 5speed???????????? ANyone?????????????

User Avatar

Inspect the front tires they may have a bubble on one of them it is possible that a wheel bearing is going out but the easy check is to inspect the tires after you have driven it a few miles

User Avatar

This happens rarely, but has happened to me a few times. What I have learned is, I depress the pedal and start it up again, and this seems to work (leave the pedal depressed and release when it starts up).

User Avatar

start up and in gear. vacuum diaphragm releases lock on pedal

User Avatar

From what I can tell, the rattle is most likely coming from your alternator, Take It In!

User Avatar

路 Rattle 路 Recorder 路 Reed

User Avatar

路 Rattle 路 Recorder 路 Reed

User Avatar

We have a 95 Camry and had the same problem when changing our starter, and had to disconnect the battery cables. Check on the floorboard underneath the emergency brake pedal, there may be a small toggle swith. Try flipping the switch, and it should start. The Toyota dealership told us it was what we had to do to ours, and it started afterwards. good luck!

User Avatar

1. Turn the ignition to the "on" position 2. Wait three seconds, then press the gas pedal (very hard) 5 times within 5 seconds 3. Release your foot from the gas peddle for 7 seconds 4. Push the gas pedal down for 10 seconds (SES Light should start to blink) 5. Release the gas pedal for 10 seconds 6. Push the gas pedal again holding it down for 10 more seconds 7. Release the gas pedal and turn the ignition to "off" 8. Start the car, your ECU should now be reset.

User Avatar

tell me the mileage and i will let you know about the rattle

User Avatar

start with dynamite....... start with dynamite.......

User Avatar

The problem has overcome now, as such at present there is no problem to start this project.

User Avatar

CHECK ALL FUSES FIRST. YOU CAN PUT THE CAR IN NUETRAL AND START IT THEN GO FROM THERE,,

User Avatar

rocking chair receiving blanket rattle

User Avatar

marharby is a rattle snake that is awesome and bites people

User Avatar

Start the car, press breaks, switch to neutral gear, turn the engine off, release breaks (use manual breaks).

User Avatar

Unless you are talking about a manual transmission, you do the same when you start it normally but you can also use the hand brake the same as the pedal brake. If you using a manual transmission you have to release the clutch just enough to hold the car in place when you take your foot off the brake pedal. This keeps the car from rolling backwards. Then you release the clutch while pressing on the accelerator. It takes practice.

User Avatar

Yes they can rattle. It normally happenes for one of two reasons. One, the outer heat shield rusts loose. Two, the inner structure of the converter fails and turns into a big lump that bounces around inside. Yes they will rattle when they are wearing out and bits and peices of the inner material start coming out and start vibrating around.

User Avatar

The pedal of a sewing machine controls acceleration. To start sewing, you press on the pedal with your foot. The harder you press, the faster it goes.Speed. How fast you want the needle to go

User Avatar

Rattle is a baby item. It begins with the letter r.

User Avatar

depress the brake pedal and turn the engine switch to the start posiiton and start the engine,,, Does this mean to hold the brake down until you hear the engine start.

User Avatar

http://www.allpar.com/fix/nostart.html

User Avatar

Chevy, Camry, Corrola, Chrysler, Corvette


Copyright 漏 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.