0
On my 1996 tracker the check engine light is on for EGR and TORQUE CONVERTER CLUTCH CIRCUT MALFUNCTION.I talked to a local transmission shop and he said it was a automaic transmission lockup solinoid.Its just inside the transmission pan and i believe it has only 2 wires.I ordered mine from napa for about $45.00 and should get it tommorrow.I'll change fluid and filter at the same time.My tracker shifts fine but i do here a noise that seems to come from that area sometimes upon acceleration and deceleration.Its sounds like a vibration..I'll let you know if it works.Autozone read the code but didnt have any idea on how to fix it.Hope this helps ..
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you lock the hubs on your Geo Tracker?
lock them in tight.
How do you replace a torque convertor lock up solenoid?
UNPLUG IT! I DID & HAVE HAD NO PROBLEMS YET & THAT WAS A YEAR AGO!!
What would cause the anti-lock light to turn on in a 1994 mustang gt?
There are many reasons why the anti-lock light would turn on in a 1994 Ford Mustang GT. One reason are bad ABS sensors.
How do you change the ignition lock cylinder in a 2001 Chevrolet Tracker?
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
Is the input shaft splines on a lockup th350 different from a non lockup th350?
yes they are because of the lock up convertor used.
Can you put a th350 torque converter in a th400?
yes as long as it is not the 350C lock up convertor and have or need the right stall for your needs.
Anyone make a locker for front of Geo Tracker?
Trail Tough now has a Lock Right front locker available for the Geo Tracker/Suzuki Sidekick. Go to their Products then Tracker/Sidekick section. http://www.trailtough.com
How do you get the spare tire off of a 1995 Geo Tracker?
Our 1995 Tracker Sidekick has a spare on the rear door , it has a tire lock that your ignition or door key should unlock, however our keys do not fit the lock. I may have to drill or grind it off and replace it with anotherone
Door key does not lock all doors on a 1994 Nissan Maxima?
key does notopen or lock doors on a Nissan maxima 1994
1994 Oldsmobile 88 power door lock fuse location?
were is the power door lock relay on a 1994 olds 88
To see this part anti - lock brake control module for a sentrnissan a 1994?
to see this part anti - lock brake control module for a Nissan sentra 1994
How do you remove and replace an ignition lock cylinder on a 1994 Ford Bronco?
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
