Under the intake manifold. where is the intake manifold!
underneath the intake manifold next to the oil filter
The EVAP purge solenoid on a 2001 Nissan Sentra GXE is under the hood. It is mounted to the top of the intake manifold.
The coolant drain plug on a Nissan Micra engine block is on the upper part of the block. It is under the intake manifold.
PCV VALVE - Under hood, center, upper engine area, mounted in intake manifold
On intake manifold.
Coolant temp sensors are typically somewhere on the intake or on the cylinder heads. They have no more than 2 wires going to them, most of the time only one.
you have a coolant leak
Intake manifold at top of engine?
Need to check the 4 corners on the intake manifold. It is common for the intake to leak engine coolant.
The engine coolant temperature sensor and coolant temperature gauge sender are located on the passenger's side of the engine, under the intake manifold.
Under the intake manifold, u need to completely remove your intake manifold to Access it..
its in the intake manifold
No, the head gasket is underneath the heads where they mount onto the block. Your intake manifold is bolted to the top of your heads. Some motors have coolant that circulates in the intake manifold ( I don't know what year or make your vehicle is ) so I would check my shop or repair manual. There could be a crack where the coolant flows through your intake manifold or one of the manifold gaskets may need replacing.
intake manifold gasket if it is coolant in the oil
what are the torque specs and sequence for a 1992 Nissan maxima manifold
On top of the valve cover there is a hose coming out of it and into the air intake manifold. Removing the hose from the valve cover side will expose the PCV valve.
The PCV valve is located on the back, drivers side of the intake manifold in a short, rubber hose. It is threaded into the intake manifold close to the last "N" in Nissan which is imprinted into the intake manifold. It requires a 3/4" wrench to remove it.
On the intake manifold.
Most of the time - yes
In between the air box and intake manifold.
The knock sensor for most Nissan V6 engines is located directly under the intake manifold. So to replace it, you have to remove the intake manifold. Good Luck.
coolant by pass hose needs repaced under intake manifold to water 1996 Lincoln town car