answersLogoWhite

0


Best Answer

vacuum leak

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would my 89 Honda prelude lose power while driving?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

93 Honda Prelude cuts off while driving?

main relay


Why would a 1997 Honda Prelude stops running while driving down the road then won't restart but still have power Any ideas?

it could be of running it with out oil.


Why put high speed tires on Honda Prelude?

It is safer and improve handling while driving in higher speed.


89 Honda Prelude jerks while driving?

Loose nut behind the wheel. Loose nut behind the wheel.


What would cause a 92 Honda prelude to act like it is wanting to cut off while driving?

If you mean 'cut off' as in the car dies while driving its probably your alternator.


1999 Honda accord ex v6 lost power while driving?

Have your alternator checked


Will a 2000 Honda Prelude base model engine fit into a 1993 Honda Prelude 93 Honda Prelude?

Not without electrical work. The 1997+ Preludes have OBD2 wire harness while the 92-96 Have OBD1. Different wire harness/sensors/ecu.


What is the worst thing that could happen if the timing belt on a 1989 Honda Prelude Si breaks while driving?

The valves could hit the top of pistons & ruin the engine.You should have this replaced a.s.a.p.


Honda z50 leaking fuel while driving out the drain hose?

fuel leaking out drain hose while driving Honda z50


Why the tachometer goes to zero while driving on a Honda Accord?

Bad connection somewhere? Loss of power? (check and wiggle fuse)


Will 92 seats from a Honda Prelude fit in a 95 Honda Prelude?

The front seats can be swapped out. The rear seats however cannot, as the 92 model had a partition down the middle, while later models in that generation had a more standard seat setup.


What would cause an intermittent speedometer and dash warning light while driving a 1992 Honda Prelude SI4WS?

Remove the assembly and check the connectors.. removing the assembly is a little tricky, so be careful and try not to break anything!