0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why would you tap the brake pedal?
To send a signal to the driver behind you.
How do you pedal faster in grand thef auto san Andreas in computer?
Tap W repeatedly.
Is it true that a car's break system multiples the force of the driver's tap on the brake pedal?
Yes.
True or false a car's brake system multiplies the force of the driver's tap on the brake pedal?
true!
How do you get a 4runner out of park?
Shifter is blocked by a device attached to the brake pedal. If the brake pedal is not depressed it wont allow you to change out of park. There should also be a bypass button next to the shifter, in case the cable to the pedal breaks.
If you experience a jammed gas pedal?
Jammed Gas Pedal � Keep your eyes on the road. � Tap the gas pedal with your foot. � Try to pry the pedal up with the toe of your shoe. � Shift into neutral. � Turn off the ignition. (Do not turn the key to lock, or your steering will lock.) � Use your brakes.
What would cause a car to jerk really bad when putting foot on the gas?
When a throttle cable is too tight any slight tap on the gas pedal could cause the car to jerk forward. The throttle cable should be adjusted to allow more play on the pedal.
How do you get rid of the rear light indicator on the dash board it appears when breaks are applied and stays there always?
It looks like a sticky contact... I would dissassemble that part (ussually it's a button with a nut on a brake pedal or it touches the pedal) clean , and a little bit of grease. You can spray wd-40 in there but I would not recommend it.
Why is a Chrysler 300 stuck in park?
Depress brake pedal. On a 2005-2008 there is a spring retainer that breaks inside the shifter.
If the brake light switch is not on the pedal where else would it be on a 2004Passat?
It should be on either the pedal shaft or the pedal frame.
You need to know why you keep losing your breaks on your 96 golf your pedale looses pressure even after you changed your master cylinder and breaks?
leaking wheel cylender if you can pump the breaks up you have air in the lines but if they up without pumping them and you loose pedal you most likely have a leaking breakcylinder but I would also check for a broken breakline if you are loosing fluid...good luck
What you should do to drive in reverse?
well first you have to shift it into the reverse gear. then you look over your shoulder (right if you're backing out right left if you're backing out left) and very, very gently tap the gas pedal. Most of the time the vehicle will back itself out without the gas pedal but if it isn't moving then gently tap the gas.
