0
What else can I help you with?
Why would you get a whistling noise when you press the brake pedal down on your 2000 F-250?
Brake booster problem?
What could cause the brakes and brake pedal to stick when brake pedal is pressed?
Check around brake pedal for something rubbing. If OK, I'd look into the master cylinder.
If your brake lights do not come on until touching the floor board what would you do to increase sensitivity or what would you replace?
Adjust the brake switch located on either the brake lever itself, or it will be attached underneath the dash. SOunds like your brake switch is off or broken. Look at the brake pedal and there is a switch around it that gets activated by you pushing the pedal - that is what needs to be adjusted or replaced. The brake light switch has probably come loose or broken. Look under the dash near the brake pedal arm. There is a switch attached to a bracket.
What causes hard brake pedal in VW beetle?
Any time the brake pedal is hard to press then you need to check and see if the brake booster is functioning properly.
2002 ford explorer brake lights stay on all the time?
check brake light fuse and brake light switch on pedal
True or false a car's brake system multiplies the force of the driver's tap on the brake pedal?
true!
Is it true that a car's break system multiples the force of the driver's tap on the brake pedal?
Yes.
What is meant by brake pedal pads?
It would be the rubber pad that sits on your brake pedal. Unless they were referring to brake pads, which are the pads which enables your vehicle to stop by pressing the brake pedal.
What would cause the brake pedal to be hard and still no brake lights on a 2006 Lincoln navigator?
brake switch located on the top of the brake pedal
Can a brake pedal malfunction make your brake lights not work?
Usually that would be caused by a faulty brake light switch connected TO the brake pedal. If the brakes work the pedal is probably ok.
Does a car's brake system multiply the force of the driver's tap on the brake pedal?
Yes. Most cars have a hydraulic braking system that uses a vacuum servo (or booster). It is a mechanical device between the brake pedal and the master cylinder piston. The booster uses the engine's manifold vacuum to amplify the force applied from the brake pedal.
What would cause brake lights not to come on until the brake pedal is all the way compressed?
Check the switch adjustment on the brake pedal arm.
If the brake light switch is not on the pedal where else would it be on a 2004Passat?
It should be on either the pedal shaft or the pedal frame.
What would cause a soft brake pedal on a 2000 Grand Caravan?
out of brake fluid?
Where is the switch under the brake pedal you cant find it?
It is above the brake pedal not under it. Follow the brake pedal bracket all the way up and you will see the brake pedal switch.
Why would the brake pedal be soft?
if brake pedal is soft , either there is air in the system ,a brake fluid leak, or brake linings and pads are worn allowing the pedal to travel to far if there is a fluid leak, this can usually be found by getting under vehicle and looking at inside of wheels for brake fluid
Why would an icon on the dashboard comes on when the brake pedal on a 1997 Toyota Camry is depressed?
A dashboard light appearing when brake pedal is depressed usually means brake fluid is low.
