0
What else can I help you with?
Where are beams used?
Beams are used when you are driving with no one in the affected area, and you lack the extra light that you would normally have when in "town" or suburban area.
What is a reflection on a science fair project?
Looking back on your experiment, what would you change?
If you added blue light to blue light would you get white light?
no. Answer: If you mix red, green and blue light, that's what you get - white light. An interesting observation can be made by overlapping beams of the above colours.
How would one use an apostrophe to spell the cars beams?
If it is one car - you would use "The car's beams" - If it is more than one car, you would use "The cars beams"
Why would only your hi beams work on your 1994 F-350 and not your low beams?
low beams my have burned out
When should you use your high beams on a motorcycle?
As you would with a car. Most places have laws against using high beams within city limits, but on the interstate or outside cities and towns where streets are well-lit, definitely use your High beams. Make sure to drop to low beams with oncoming traffic though. Hope this helps!
Why do the high beams not work even though running and normal beams work fine on 2001 Sunfire?
Does the car have fog lights? I have a 2003 Sunfire that the high beams would not work on. This was caused by a short in the fog light wiring. I had the fog lights rewired separate from the harness (about $100) and the problem was fixed.
How do you switch on your fog lights while using highbeams on a 2001 explorer?
Why would you? Fog lights are designed for use in poor driving conditions such as fog or rain at night. Using high beams under those conditions would make matters worse, that's why your vehicles fog lights won't operate when the high beams are on.
What would cause my low beam headlights on my 1991 Nissan pickup to not work when high beams work fine It is not the headlight?
bad light switch.
Is there a light inside of the microwave when it is not in use?
No, when it is not in use, the microwave would not have a light on. Why would you want the light on when you are not using it and waste energy?
Why would someone jerryrig the low beams on a 1994 Le Baron to make the low beams work Wire from battery operates low beams Low beams do not work high beams do and so do parking lights?
Bad dimmer switch.
Why would the high beams on a 1994 Thunderbird work when the low beams do not?
Headlights have two filaments; one for low beams and one for high beams. There is a good chance that the low beams are burnt out. This doesn't necessarily mean that the high beams won't work. However, it's not too common for both low beams to burn out at the same time. Of course, it could be a fluke. I would replace the headlights with new ones and then go from there.
