answersLogoWhite

0

Why would our 1988 Camaro start hard?

Updated: 8/16/2019
User Avatar

Wiki User

15y ago

Best Answer

Needs new plugs and wires or just a good tune-up.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would our 1988 Camaro start hard?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the ground wire on a 1988 Camaro?

its bolted to the block.. just follow the cord its not hard...


My 1988 Chevy Camaro is hard to start and the check engine light came on then went off after changing the starter Could this car need a tune up?

Hard to start as in??? Hard turning over - check connections at starter & battery, Turns but won't fire - check tuneup & ignition areas


Why would the service engine light come on on a 94 camaro V6 and be hard to start when cold after replacing the thermostat?

have vehicle scanned to determine the problem


1988 Camaro 6-cylinder- Hard to start- unstable idle - the rpm will fluctuate while holding holding the accelerator steady?

check you idle control valve it can cause those symptoms also your throttle positioning sensor


1988 Quadrunner is hard to start?

# it could be the batte or the olternater


What would make a 1988 old ciera hard to start have a rough idle and backfire?

Poor maintenance and/or bad ignition coil.


Will a 1998 hard top Camaro door fit a 1995 Camaro convertable?

Yes


Why would the breaks be hard on my 1994 camaro z28?

BAD power brake booster are a vaccum leak at the booster.


How do you replace a heater core on an 81 Camaro?

its hard you have to take the whole dash out to reach it i had a camaro and it was b****


Why does your 1989 camaro run rough and it is hard to start you have done a tune up plugs wired and air filter new mass senator?

it may be out of time have your timing checked


Why do you lose power when accelerating hard in Camaro ls1?

because its a ls1


Where is the starter located on camaro?

under the passenger seat but its hard to removed it