Dashboard Lights and Gauges
Ford Contour
Ford Explorer
Dodge Stratus

Why would the abs light stay on continuously in a 97 contour GL?

202122

Top Answer
User Avatar
Wiki User
2007-03-31 22:02:28
2007-03-31 22:02:28

why would the abs light stay on continuously in a 97 contour? I own a 1998 ford contour and the abs light is on all the time. my car which needs new breaks because when the abs light comes on you could have three wheels grabbing when you hit the breaks or two wheels grabbing. what i would do is either check to see if you need new breaks or they just may needed to be adjusted. your rotors could be so worn down that they could also need to be replaced or honed out.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Could be low on brake fluid. This is a sign that the brakes need attention.

User Avatar

There's something wrong in the ABS system, obviously. Wheel speed sensors are the most common cause I've encountered.

User Avatar

On a map, a contour line connects points of the same height below or above sea level. The elevation would stay the same if you followed a contour line.

User Avatar

Could be a bad oil sending unit Have you got oil int engine. it not, you got a big problem.

User Avatar

Need to look at your door switch. It has a plunger on the end. The end might have broken off or the nut holding it might have come off causing the switch to recess back into the hole.

User Avatar

It is important to know what the meanings of the emergency lights on a ca. A brake light would stay on in a car because the brake system needed to be fixed, and the light needed to be reset.

User Avatar

Red Light - indicates if the cycle is on or off. The red light will blink for 3 minutes and turn off for 3 minutes, the cycle will continuously repeat as long as Riddexยฎ Power Plus is plugged in.

User Avatar

Easiest way is to disconnect the negative battery cable for a couple minutes then reconnect. This will clear the error codes from the computer. If everything is okay, the CHECK ENGINE light will stay off.

User Avatar

Friction affects the world a lot. With out friction, we would have no grip. We will continuously slide. Nothing will stay still - unless stopped by a wall.

User Avatar

A malfunctioning sensor can cause the service engine light to stay on. A glitch in the computer can also cause the light to stay on.

User Avatar

You need to have the ABS system scanned with a computer to determine the reason for the light staying "on"

User Avatar

There are many reasons why a head light would stay on when car is off. These lights could be automatic.

User Avatar

That would happen if the alternator is over or under charging.

User Avatar

The airbag light stays on when the computer detects a malfunction and sets a code.

User Avatar

why would a 1995 ford f150 interior and cargo lights stay on with the doors closed ?

User Avatar

Stuck brake light switch, or a short to power somewhere in the brake light circuit.

User Avatar

i would have the light switch checked to see if it is faulty

User Avatar

It's impossible, but if you were time would stop


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.