0
Why would the clock light stay on in my 1996 Beretta even after the car switch is off?
Wiki User
∙ 9y ago
It should be on a delay and shut off after 10-20 minutes.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Why would your brake light be on 1993 Chevy Beretta?
Brake light switch defective or out of adjustment.
Why would all the lights stop working on a 1989 Chevy beretta?
MAYBE YOUR BREAK SWITCH ON BREAK PEDAL IS BAD OR MAYBE A GROUND BUT I WOULD DEFINATLY CHECK YOU BREAK SWITCH
Which light would turn on if switch a would close but switch b would remain open?
i think light two would turn on because it is in the middle of switch a and b
What would make a light turn off and on?
a light switch
What would cause the clock light not to work on a 2002 Honda Accord SE?
The lightbulb for the clock is blown.
Would a light switch converts electrical energy?
No. A light switch merely allows energy to pass, or not to pass.
To mount two switches and a pilot light in a single gang standard device box you would use?
You would need to purchase a duplex switch. As for the pilot light look for a duplex switch that has a neon pilot light that is incorporated into the handle of the switch. When the switch is turned on the switch's handle will illuminate.
Why would your brake light be on 1989 mercury marquis?
Brake light switch stuck, defective, or out of adjustment.Brake light switch stuck, defective, or out of adjustment.
Why would a husband suddenly tell wife im not ready for sex yet?
It's not a light switch! It's not a light switch!
Installation of brake light switch for a 88 gmc serria?
how would remove brake light switch and replace on an 88 gmc
What would you use a u switch for?
You would use a u switch for turning off and on a light, like a light switch. It could be used as some sort of an electric converter to power anything in your house or where ever you are.
What alteration would occur if a single pole switch is reconnected to become a master switch?
If a single pole switch is wired to be a master switch, the switch would have to be in the on position for any other control devices to operate. Turning the master switch off would eliminate power to all devices (and/or loads) which it was serving. For example, some homes have a switch to control their outside light. If the outside light has a photo eye (the light will only come on at night), the switch is the master switch. Another example would be the breakers in an electrical panel. Each breaker would be the "master switch" for the circuit it protects. The main breaker in the panel would be the "master switch" for the entire home.
