answersLogoWhite

0


Best Answer

Fuses That "Blow" Repeatedly

Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, none of us can identify the specific defect which is causing your problem.

Therefore, the following generic answer can be applied to any electrical circuit, whether in a vehicle, or in a building, whether direct current [DC], or alternating current [AC].

Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors.

And in a worst case scenario, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.

When a fuse or Circuit Breaker [and replacement fuses, or repeatedly "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.

The fuse or circuit breaker is doing what it was designed, intended, and installed to do; that is to protect the conductors and components of the circuit which it serves.

The proper "fix" for this issue is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].

Some ignorant few people will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it.

Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an oversized fuse would almost guarantee damage to the wiring and the probability of an electrical system fire.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would the ecm-ign fuse blow when putting truck into drive?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Do I need a special license to drive and operate a chipper truck?

It would depend on the size of the truck. In most cases you would not.


What needs to be done after replacing a hard drive?

Generally, you would need to set up the drive. It starts with partitioning the drive, putting a file-system on it, and then putting data on it, perhaps data recovered from the old drive or the backups. It is was the primary drive, the OS would need to be installed.


Why would your truck bogg taking off after taking 323 gear out and putting in a 410 and truck is running fine.?

Check your timing


Why would a truck slip into 4 wheel drive?

synchronize


What does drivetrain mean in a truck?

The drivetrain of a truck would be all the components from the engine to the rear drive wheels.


Do you need a CDL to drive your own truck?

If it's a truck which anyone else would be required to have a CDL to drive, then yes.


Would a guy like it when a girl has a truck or expensive car?

When I drive my husbands truck...men turn their heads.


Do you need a special license to drive a garbage truck?

A Class B license would be all you need to drive a garbage truck. This is a special class license used to operate certain vihicles such as the garbage truck.


What does it take to convert a 1990 GMC 1500 2 wheel drive truck to a 4 wheel drive truck in a 1990 GMC 1500 4 wheel drive?

You could do it but it would be much cheaper to just buy a good used 1990 GMC 4+4 truck and drive it.


Would putting 26 inch rims on a truck ruin the transmission faster?

It would not affect anything. the size does not mater.


How to make a 1987 Chevy R10 rear wheel drive truck a four wheel drive truck?

The entire drive-train minus the engine, plus the entire suspension would need to be changed. Tires would also need changing. This is possible, but a very daunting task. You would need to have a donor truck in order the acquire all the parts necessary. Otherwise the cost would be in the thousands of dollars. I would suggest you sell the 2wd truck you have and purchase a 4wd.


Is it illegal to drive a semi-truck barefoot?

You can drive barefoot if you wish, although it probably would not be a recommended practice.