Red lights flashing on a school bus mean remain stopped until they are turned off.
You must remain stopped until the red lights stop flashing.
In ultrapure water the indicator remain unchanged.
Under normal use, the exterior of this microwave should remain relatively cool.
it will remain the same
The indicator remain blue.
a short circuit. Somewhere the wires are shorted and drawing power from elsewhere, you could remove and replace the fuses one at a time to give you some clue as to where the power is being drawn from then consult a wiring diagram to chase the short down.
They remain the same.
Turmeric remain yellow in acidic solutions.
it will remain neutral as products of neutralisation are salts and water
Because there is a problem, and you don't realise it!
Turmeric (curcumine) remain yellow in acidic solutions.
You can use an indicator like litmus paper its colour will remain same if the solution is neutralized and also can use universal indicator when you pour a drop of it and it changes its colour to green.
If there are pedestrians still crossing when the amber light is flashing, the motorist must remain stationary. If there are no pedestrians crossing, the motorist can proceed. (But, be careful of pedestrians taking a chance and attempting to cross when the amber light is flashing - it is best to use caution until the light turns green.)
The reason a high beam indicator light might remain on in the dash of a 2005 Nissan Sentra might be a short in the wiring for the high beam headlights. It could also mean a short in the wiring of the steering wheel where the high beam switch is located.
What happens when light inthe shape of a car comes on: Make sure the lights are oem purchased lights and not from a auto zone or other parts store. The rear prones has to match correctly or waring will remain on dash.
If it is equipped with the automatic transmission - the "P" indicator on your gear selector will remain lit for 16 minutes after shutdown. After the 16 minutes has passed, you'll notice the lamp has gone out. That is your indicator that the vehicle has entered "sleep" mode (when the light is out).
That means you have a fault in your electronic throttle control, take your BMW to a reputable import shop or your local BMW dealership.
Check the brake light switch, it's under the dashboard, connected to the brake pedal.
Typically the light will remain on if the fluid is low, or maybe the ebrake just pulled just enough that it is on..... or the switch that is triggered by the handle is faulty
You don't say what kind of car so make sure all of the wires were hooked up correctly.
The light is on because there is a problem with the system. Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself after a short drive.
This is a diagnostic code. You can perform a recalibration by turning the temp to cold and the fan on high. Then hold the rear wiper and rear washer buttons down together. The lights will flash and the test will begin. The test and recalibration concludes with the rear wiper lamp flashes. Press it to end the test. If any other lamps remain flashing note them and got to your dealer for the diagnostic decode.
Phenolphthalein and other indicators which themselves are weak acid show a colour change in basic medium (between pH value 7.1 to 14) so in acids they remain unchanged.