answersLogoWhite

0


Best Answer

Here are several answers and opinions from FAQ Farmers: * Sounds as if you haven't driven far or run the engine long. Most likely an air block or bubble hard to travel through. The engine will take in fluid due to the water pump running but may not be pushing all the air out. Then when it sits air is pushing fluid up and out but air hasn't yet escaped. Sometimes a weak water pump may not be circulating good enough low flow and not push all the air out. Run engine with cap off start out cold and watch fluid if goes up and down in radiator then air is still present. add fluid until full and keep watching and adding. Thermostat could also not be opening all the way and air is locked behind and can not escape. * You probably have air in the system. Did you bleed air out of the system when you replaced the radiator?

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would the overflow tank be completely empty when you turn off the engine but its full the next morning even after installing a new radiator?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When you can say that you are physical fit?

Early morning i am completely physically ft ...


Is it true that morning breath contains feces?

No thats completely false.


When is Mass supposed to be said In the evening or in the morning or both?

When you say mass is completely up to you. Church holds mass in the morning and sometimes in the evening. It's flexible.


Can you drink coffee the morning of your cholesterol test?

Yes, if it's black. It's better to fast completely though.


What type of window blind should I purchase that would black out the morning sun completely in the master bedroom?

Many metal blinds will stop all light from passing through even the morning sun.


What does it mean if you like this woman you say morning to her she says morning back then she sometimes weirdly avoids you ignores you until you get the perfect time to say morning to her again?

Ngl, she doesn't like you bro. If she did, she would send you fake love letters, and then you would turn her down and completely crush her soul.


How do you avoid pad overflow at night while on period?

Try wearing two maternity or overnight pads. Some women use two tampons, ensuring to remove the second one next morning. Or use the extra-super absorbent type.


In night the water level goes downwhen you start in the morning the level raise up what will be the problem inthe car radiator?

I would start with the head gasket. I had same issue. High compression leak when its cold, but when its warmed up the metal expands and it closes up the worn gap of the gasket. FYI its not the Radiator.


Why did the meat had to be completely consumed before morning came during the festival?

This applies only to the relevant sacrifice(s), not to all meat. Certain sacrifices had to be eaten before the morning; this is a Biblical decree and has no explanation - like most other Godly decrees.


How can you create a cozy kitchen nook?

If your kitchen has the space, a cozy breakfast nook can be created. Installing a bench along a wall is the first step. Add a small table and a couple of chairs, and you have the perfect spot for your morning coffee.


Is child in a manger the same as child in a manger born?

No. Child in a Manger is to the tune of Morning has Broken, whereas child in a manger born is a completely different song.


Where is the radiator cap located in a 2001 Saturn SL1?

It's a sealed system, there is no cap. READ NEXT BIT IF YOU HAVE COOLANT LEAK!!! *This next portion edited by separate searcher/learner* Thanks Clay for your answer, I found the same... there is NO radiator cap on this particular model/year. I searched for this information because I was caught in a bind and needed a quick fix until I could properly maintenance my vehicle and replace the radiator myself. My problem: I discovered a decent-sized leak (ie constant stream/squirt) on the metal, driver's side end of my radiator and needed to drive across town early the next morning for work-- so I bought a reputable brand of coolant "stop-leak" (Aluma seal) from a parts store, but when I went to put the product directly in the radiator (and NOT just in the overflow reservoir) as it specifically tells you to do, I ran into the problem of it being a closed system. I therefor improvised and bypassed this problem by loosening/detaching the upper hose (driver's side attached to the radiator) on the end closest to the firewall-- to allow for siphoning when you're ready to pour the 'stop-leak' product into the radiator. I just poured it in, whether it's the dry-powder form or pre-mixed form, into the hose, waited for it to drain into the radiator, then followed it up with a 50/50 mix of coolant/water to make sure it all made it in the radiator. I may have improvised here, but you gotta do what you gotta do when you're in a 'bind'. I may be an amateur when it comes to home auto repair, but this actually worked wonderfully for me and allowed me plenty of time to fix/replace the radiator properly at my convenience. Just an idea, hope it helps someone out there since nothing I searched for online helped me before I tried this...