Chevy Suburban

Why would the radio in a 1998 Chevy Suburban come on by itself after you turn off ignition and remove key?

333435

Top Answer
User Avatar
Wiki User
Answered
2005-09-16 05:16:53
2005-09-16 05:16:53

Well sometimes the radio is hooked up to the ignition itself. It is just the ignition wire, if it has a disconnecting face plate then you can turn it off by taking the face plate off. Or if you would like, you can pull the radio out and disconnect the wire from the ignition and it will not still be on when you cut the truck off.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


Remove the ignition switch retaining nut. Pull the ignition out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition.


how i can removefront headrest for chevy suburban 2001


how to remove key stuck in ignition switch in Chevy colbalt



Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.


Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.


how do you remove the ignition switch on a 1990 chevy half ton pick-up?


Removing a spare tire is easy to do from a Chevy Suburban. The tire is removed with the tool that is located on with your jack.



Its right above the ignition coil. Infact you have to remove it first to remove the ignition coil.


You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.


how to remove fuel injector plug in on a 2007 chevy suburban 5.3



you remove the whell and then remove the bolts from the back of the calipier then remove the bolts from the monuting for the caliper then remove the rotor by pulling it off. if it is all one piece then you have to remove the hub itself


Remove the retaining ring at the top of your 1994 Chevy Corsica ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


You will need to remove the retaining ring from the top of your 1997 Chevy Camaro ignition switch. The ignition switch will slide out. Remove the wiring harness. Reverse the process to install the new ignition switch.


Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


You will need to remove the ignition switch retaining ring in your 2002 Chevy Astro Van. Slide the ignition switch out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.



test ignition coil,ignition module,pick-up coil,electronic spark control,and knock sensor


how to remove cross bars on a 2011 gmc yukon


Chevy Tahoe Ignition Key Starter Switch


i have a 06 Chevy cobalt and can't get the key out of the ignition switch



How do I get the front grill off my 1997 Chevy suburban? I've removed the six visible screws holding it in place, but it still won't come out..



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.