Chevy Blazer
Windshields and Wipers

Why would the wipers on a 95 Blazer stop working and then maybe a little while later they will start working again?

363738

Top Answer
User Avatar
Wiki User
2015-07-17 17:41:33
2015-07-17 17:41:33

It has a circuit bereaker in the motor which can be weak or the linkage and transmissions can cause unusual drag on the motor. Have it checked out,

I had the same problem on a GMC wiper motor of similar vintage. Solved with adding a specific ground wire from the wiper motor houseing to the frame.

I have a 1997 Blazer that had the same problem. There was a recall on the wiper circuit board that fixed the problem. You may want to try if the recall was for your year of truck also.Jeff

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

i was driving in the rain last night my headlights and wipers quit working and i stop the car for 15 minutes and they starting working again and they are still working what could have cause this my car is 2002 cavalier

User Avatar

There is most likely a sensor which moniters the fluid and renders the wipers useless when empty

User Avatar

I have a scenic 06 plate. My wipers have stopped working about 4 times in the last 6 months, which is not an enjoyable experience when on the motorway in the rain. I have to switch the ignition off and on to get them working again. Just about to book it into the garage (to probably have them tell me they 'can't find anything wrong with them sir'.)

User Avatar

Does your car Perhaps have Delay Wipers must cars these days do you know.

User Avatar

the windshield wiper motor could be getting Hot! Mine does the same thing, then when it cools off they work again.

User Avatar

If your wipers were froze down or stuck down when you tried to use them. It maybe the wipers are designed so that the bolt which is fastened to the fire wall backs off. try tightening that bolt and see if they do not been working again! From LHZ

User Avatar

for me also its not working. It's showing like this... "It's a little crowded, Please wait for a moment and try again"

User Avatar

To eat a little bit a day and that your system can start working again. How it use to

User Avatar

would you consider working again for us

User Avatar

I tried to restore it for a little bit, and then it stopped working again. Try to restore it.......

User Avatar

Sounds like the delay Knob may either be turned to far or need to be replaced. Check the handle for the wipers see if there is a knob oro other turning part and adjust it to the time delay you would prefer

User Avatar

Need to know what your question is, Please try again.

User Avatar

Not sure, it's been working on again off again for the past few days. Hopefully it will be fixed soon.

User Avatar

Just by pressing " P " again P - Wiper On/Off

User Avatar

when will showdown in little tokyo be aired on encore again

User Avatar

your windshield wipers are stopping/slowing because the small wiper motor, attached to the upper-right corner of the firewall under the hood, is going bad. This happened in my car. Another reason could be that your 11-year-old alternator is going bad...It doesn't matter if the alternator is giving out too much power or too little power, it effects the wipers in the way you described.

User Avatar

If you want to change only the wipers, there are some clips over windscreen wipers. You have to lift up (with your hand) the wiper and un-clip, place the new and then clip again. If you want to remove the hole system you have: *to open the hood *at the beginning of wiper construction there is one big screw remove this with a key (it might stack, so you may hit it a little bit to unstack or use oil) Then you are done. You have removed the hole windscreen wiper system.

User Avatar

I heard it is the bcm (body control module), mine goes in and out randomly, I was told that the connector gets loose after a while and needs to be secured again. havent worked it out yet, that's what I heard

User Avatar

Use another phone until yours is repaired or working again.

User Avatar

It helps control the heart and keep it's rhythm right. It gives a little electric shock if the heart stops working to start it up again. Which is good, because if your hearts not working that is bad. It is an effective electronic device.

User Avatar

first remove wiper arms from vehicle next with ignition on, turn wipers on then off. the wiper motor will stop at the down position. replace wiper arms onto shaft ,in the correct down position where you want them. now with ignition on, try wipers again,to check if in the stop position you want them.

User Avatar

if i is not working log on again or ask build a bearville on the front page

User Avatar

You accidentally disconnected the little black wire that connects to the crossover. it is easy to do. Simply plug it back in and it will work again


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.